Owner's Manual for JBL models including: Stadium Basshub, Stadium, Basshub

109STADBAS

109STADBAS, JBL Stadium BassHub 11" Spare Tire Subwoofer, WWW.CRUTCHFIELD.COM

109STADBAS;, JBL, Stadium, BassHub, 11", Spare, Tire, Subwoofer;, WWW.CRUTCHFIELD.COM

HNEWBERRY

JBL Stadium BassHub owner's manual

JBL Stadium BassHub Passive sealed enclosure with 11" dual 4-ohm voice coil subwoofer — mounts to hub of spare tire at Crutchfield

JBL JBLSUBSDBASSHUBAM | 600W RMS 11" Spare Tire Subwoofer Enclosure


File Info : application/pdf, 4 Pages, 583.22KB

PDF preview unavailable. Download the PDF instead.

jblsubsdbasshubam
~

Owner's Manual Manual del propietario Mode d'emploi

---

THANK YOU FOR YOUR PURCHASE ...
Your JBL product has been designed to provide you with the performance and ease of operation you would expect from JBL.
· Please take time to read your owner's manual in its entirety before operating or installing your subwoofer.
· Keep the owner's manual for your amplifier in your glove compartment along with the owner's manual for your car.
· Put your subwoofer sales receipt with other important documents in order to expedite warranty service if needed.
ABOUT THE MANUAL
This manual describes general installation guidelines and operation instructions. However, please note that proper installation of mobile audio and video components requires qualified experience with mechanical and electrical procedures. If you do not have the knowledge and tools to successfully perform this installation, we strongly recommend consulting an authorized JBL dealer about your installation options. Keep all instructions and sales receipts for reference. Consider this manual as an indispensable feature of your subwoofer.
WHAT'S IN THE BOX
1x Stadium BassHub 1x wiring harness 1x vehicle mounting post 1x vehicle mounting adapter 1x 2.5mm Allen wrench 1x Quick-start guide

MOUNTING THE STADIUM BASSHUB
II The Stadium BassHub mounts inside the rim of the spare tire
in your trunk. To mount the Stadium BassHub properly, follow these steps:
1. Remove the vehicle's spare mounting post. 2. Make sure that the spare tire is placed in the trunk with
the outside of the tire facing downwards; the back of the rim should be facing you. This will ensure sufficient mounting depth for the Stadium BassHub. 3. Carefully place the Stadium BassHub inside the rim of the spare tire. 4. Insert the Stadium BassHub mounting post into the slot in the center of the Stadium BassHub. When it reaches the spare tire mounting bracket, begin turning clockwise to thread the post into the bracket and tighten.
NOTE: Some applications require the use of the included adapter to provide a threaded slot for the mounting post. Insert the adapter into the spare tie-down bracket and twist to lock into place. Then repeat steps 3 and 4 above.
NOTE: To keep from damaging the Stadium BassHub or the spare tire rim, do not overtighten the mounting post.

T lX
I)
~ 0

Take out the original base
T
gilI

CONNECTING THE WIRING HARNESS
To connect the speaker wiring harness to the input on the right side of the Stadium BassHub:
1. Use the included 2.5mm Allen wrench to remove two
screws securing the cover on the top panel of the
Stadium BassHub. 2. Lift off the cover.
Insert the harness into the input.

For parallel wiring:
1. Connect the SUB1 + and SUB2+ wires to the+ output on the amplifier.
2. Connect the SUB1- and SUB2- wires to the - output on
the amplifier.

For series wiring:
1. Connect the SUB1+ wire to the + output on the amplifier. 2. Connect the SUB2- wire to the- output on the amplifier. 3. Splice the SU81- and SUB2+ wires together.

WIRING THE STADIUM BASSHUB TO YOUR AMPLIFIER
The Stadium BassHub features dual 4-ohm voice coils that
can be wired in series for an 8-ohm impedance load or in
parallel for a 2-ohm impedance load. Be sure to observe proper wire polarttx.
Plug diagram:
SUB SUB SUB SUB
2- 2+ 1- 1+
 
SUB SUB SUB SUB
2- 2+ 1- 1+

~~=v
IMPORTANT: Make sure your amplifier is compatible with your desired impedance load. Connecting a 2-ohm impedance load to an amplifier that is not rated for 2 ohms
can cause the amplifier to overheat and malfunction or
damage the vehicle.
SPECIFICATIONS
· Power handling: &XJW RMS, 1200W peak · Frequency Response: 20Hz - 150Hz · Sensitivity (@2.83V/ 1m): 90d8 · Voice Coil diameter, each: 2.5in. (64mm) · Impedance: Dual 4 ohms · Dimensions (D x H): 14-3/16" x 6-1 /2" (D360mm x
H164.5mm)

~
HARMAN
~

·HARMAN International Industries, Incorporated 8500 Balboa Boulevard, Northridge, CA 91329 USA www.jbl.com

© 2020 HARMAN International Industries, Incorporated. All rights reserved. JBL is a trademark of HARMAN International Industries, Incorporated, registered in the United States and/or other countries. Features, specifications and appearance are subject to change without notice.

JBL Stadium BassHub_OM_VI



References

Adobe Acrobat Pro DC (32-bit) 21 Paper Capture Plug-in