GAMEMAX Infinity Pro

Hardware List

I/O Panel

The I/O panel provides the following connections:

• USB 3.0
• Type-C
• Reset (Reset SW)
• Combo Audio
• Power SW (Power Switch)

Detailed pinouts for USB 3.0, Power SW, Reset SW, and Combo Audio are provided in the original documentation, showing connections like VBUS, GND, SSRX, SSTX, D+, D-, NC, and audio pin configurations.

Exploded View

The chassis components are identified as follows:

• A: Tempered glass left side panel
• B: Tempered glass front panel
• C: Tempered glass top panel
• D: Right side panel
• E: Chassis
• F: HDD bracket
• G: M/B Panel Fan x3 (optional)
• H: Bottom Fan x3 (included)
• I: Rear Fan x2 (included)
• J: Bottom Dust Filter

Component Installation

Remove the Side Panel

Instructions are provided for removing the side panels. A warning states: "Tempered glass is fragile, please handle with care, and pay attention to safety!" ⚠️

PSU Installation

This section details the process for installing the Power Supply Unit (PSU) into the chassis.

3.5" HDD and 2.5" SSD Installation

Instructions are provided for mounting 3.5-inch Hard Disk Drives (HDDs) and 2.5-inch Solid State Drives (SSDs) within the case.

Motherboard Installation

This section guides users through installing the motherboard, including the use of standoffs.

GPU Card Installation

A step-by-step guide for installing a Graphics Processing Unit (GPU) is presented, covering four distinct steps.

Cooling Fan and Liquid Cooling System Installation

Details are provided for installing cooling fans and liquid cooling systems in various locations:

• Rear: 120mm Fan x2 (included), 120mm Liquid cooling system (optional)
• M/B Cover: 120mm Fan x3 (optional), 140mm Fan x2 (optional), 120/240/280/360mm Liquid cooling system (optional)
• Bottom: 120mm Fan x3 (included)

It is recommended to use a reverse blade fan at the bottom. The document also includes a guide for the V1.9 FAN HUB & RMT-AP CONTROLLER, detailing connections for SATA, ARGB, and PWM headers, and warning about incorrect power interface connections: "Please do not plug in the wrong power interface, otherwise it will burn out equipment!" ⚠️. A note clarifies that fan connectors are connected sequentially to the V1.9 fan Hub.