Automotive OEM integration | CRUX Interfacing Solutions
Instruction Manual for CRUX models including: SWRHN-62B, Radio Replacement Interface, SWRHN-62B Radio Replacement Interface, Replacement Interface, Interface
Crux SWRHN-62B Wiring Interface Allows you to connect a new car stereo and retain steering wheel controls and aux input in select 2006-11 Honda vehicles at Crutchfield
File Info : application/pdf, 2 Pages, 1.02MB
DocumentDocumentINTERFACING SOLUTIONS R + RADIO REPLACEMENT SWC RETENTION SWRHN-62B Radio Replacement with Steering Wheel Retention for Select HONDA Vehicles PRODUCT FEATURES: - Retains factory features in select Honda vehicles while functioning with an aftermarket radio. - Pre-programmed to retain factory Steering Wheel Controls. - Retains Factory Auxiliary Input. - Includes Antenna Adapter. - EIA color coded wiring for easy installation. NOTES: 1. Does not support amplified systems. 2. Does not retain Rear Seat Entertainment system (RSE). 3. Does not retain factory navigation system. PARTS INCLUDED: SWRHN-62B MODULE SWRHN-62B HARNESS ANTENNA ADAPTER SWC CABLE INSTALLATION DIAGRAM: 12V Constant Yellow +12V ACC Red Ground Black Amplifier Turn On Blue/White Illuminaon (+) Orange/White Illuminaon (-) (Not Used) Orange/Black Right Front (+) Gray Right Front (-) Gray/Black Left Front (+) White Left Front (-) White/Black Right Rear (+) Violet Right Rear (-) Violet/Black Left Rear (+) Green Left Rear (-) Green/Black Vehicle Speed Sense (VSS) White/Green Security Signal (Not Used) Brown Aux Detect (Acve-Low) Red/Black K Line (Not Used) Yellow/Black TO FACTORY HARNESS AFTERMARKET RADIO 12-Pin Black Connector ON RADIO VEHICLE 1 2 3 4 5 6 7 8 SWC MODULE AFTERMARKET HONDA RADIO SELECTOR SWC SETTING (See Chart) (OFF ON ON OFF) ON RADIO VEHICLE 1 2 3 4 5 6 7 8 3.5MM SWC CABLE Plug in the 3.5MM SWC cable to the 4-pin port on the module. See "DIP SWITCH SETTINGS" section. 4-Pin Connector BLUE / YELLOW (for Kenwood & JVC) Insulate with tape if not being used BLUE / Power Antenna 1 of 2 Crux Interfacing Solutions · 21541 Nordhoff St., Unit C, Chatsworth, CA 91311 phone: (818) 609-9299 · fax: (818) 996-8188 · www.cruxinterfacing.com rev.030519 INTERFACING SOLUTIONS R + RADIO REPLACEMENT SWC RETENTION SWRHN-62B Radio Replacement with Steering Wheel Retention for Select HONDA Vehicles DIP SWITCH SETTINGS: HONDA STEERING WHEEL CONTROL DIP SWITCH SETTING: DIP: 5 6 Honda OFF ON 7 8 ON OFF AFTERMARKET RADIO DIP SWITCH SETTINGS: SWC MODULE ON RADIO VEHICLE 1 2 3 4 5 6 7 8 RADIO BRAND: DIP: 1 2 3 4 Dual, Fahrenheit, Jensen, Pioneer OFF OFF ON ON Power Acoustik, Soundstream OFF OFF ON ON Alpine OFF OFF OFF OFF Clarion OFF ON ON OFF Kenwood OFF ON ON ON JVC OFF ON OFF ON Boss, Old Sony OFF ON OFF OFF New Sony OFF OFF ON OFF SWC MODULE ON RADIO VEHICLE 1 2 3 4 5 6 7 8 3.5MM SWC CABLE Plug in the 3.5MM to 4-Pin SWC cable and set the DIP switches to the aftermarket radio you are using. NOTE: Insulate the Blue/Yellow or Green/Black wires if not being used. SWC 3.5MM PLUG ADAPTER: Use the supplied 3.5MM SWC plug adapter for aftermarket radios that do not have a 3.5mm SWC jack. SWC CABLE Kenwood/JVC (BLUE / YELLOW) LIN BUS (Green) (included in kit) RED to SWC Key 1 WHITE to SWC Key 2 SHIELD to SWC Ground VEHICLE APPLICATIONS: Honda 2006 2011 2006 2011 2010 2013 2008 2011 Civic / Si CR-V Insight (Non-Nav) Odyssey 2 of 2 Crux Interfacing Solutions · 21541 Nordhoff St., Unit C, Chatsworth, CA 91311 phone: (818) 609-9299 · fax: (818) 996-8188 · www.cruxinterfacing.com rev.030519