Goodnight Light Bulblite

Operating Modes

Turning ON/OFF:

• Briefly press the control button to turn the light on.
• Hold the button down for 1 second to turn the light off.

OFF Mode (Deactivating/Reactivating Remote Control):

• To deactivate the remote control, turn off the lamp and hold the button down for 5 seconds. The lamp will briefly flash to indicate 'OFF' mode activation.
• To reactivate the remote control, briefly press the button to turn the lamp on.

Selecting a Colour Mode (Ambiance):

• A brief press will turn the lamp on in white mode or cycle through available colors.
• In Rainbow mode, a brief press fixes the current color, while a second press restarts the automatic color rotation.
• To return to white light from Rainbow mode, turn the lamp off and then on again.

Illustrations show button presses for ON/OFF, OFF mode activation, and color selection.

Color Modes Table

Instructions and Precautions

Charging the Lamp

The lamp must be charged before its first use and regularly thereafter to prevent battery degradation.

• Plug in the charging base.
• Place the lamp on the charging base.
• A red indicator light glows during charging; it turns green when the battery is fully charged.
• Allow approximately seven hours for a full charge of an empty battery.

General Precautions

• Carefully read and save these instructions before using the product. Use it according to the instructions provided; failure to do so may void your guarantee.
• Do not expose the lamp to fire or other sources of intense heat.
• Do not attempt to dismantle or open the lamp.
• Do not connect the light to another device.
• Charge the lamp regularly, as the battery deteriorates after several months without charging.
• Only use the provided charging base.
• Handle the lamp with care to avoid scratching the diffuser.
• Changes in ambient temperature may cause condensation inside the plastic diffuser, but this will not affect the lamp's proper functioning.

Proper Use of Lithium Battery Charger

• Keep the charger as close as possible to the electrical outlet.
• Unplug the charger when not in use.
• Keep metal objects away from the charging terminal.
• Unplug the charger immediately if smoke appears or a peculiar odor is detected.
• Do not use the charger outdoors or if it is wet.
• Do not use the charger near mobile phones.
• Do not touch the charging base, charger, mains socket, or charging port with wet hands.
• Keep the charger away from heat sources and fire.
• Do not attempt to disassemble or reassemble the charging base.
• Keep the charging terminal clean; unplug before cleaning.
• A completely discharged battery takes longer to charge.
• Battery capacity diminishes when not in use; full capacity is restored after three to five charging cycles.
• Keep out of reach of children and pets.
• Store the charger in a dry place.

For any questions regarding the product's proper functioning, please contact your point of sale. The manufacturer assumes no responsibility for damage caused by not following these instructions.

Technical Information

• 7 LEDs (1 white, 6 RGB)
• LED power consumption: 0.4W
• Lithium-ion battery: 3.7V 850mAh
• Autonomy: Approximately 8 hours (depending on use mode and power)
• Battery life in 'OFF' mode: Several months*
• USB charging station: 5V charger not included
• Bulb power supply: 5.35Vdc-1A
• Charging time: 7 hours
• Radio range: 5m maximum (direct range)
• Diffuser material: PE Plastic
• Shock and UV resistant
• Waterproof: IPX8 (up to 1m depth)
• Recommended operating temperature: 0-40°C
• Product guarantee: 1 year

*If the lamp is not intended for use for over a month, place it in 'OFF' mode. Recharge the lamp regularly to prevent battery damage and extend product life.

Compliance

In the European Union (in accordance with Directive DEEE 2002/96/EC), and also in other regions, this product must be returned to a recycling collection point at the end of its life. Managing its end of life helps protect the environment and limit the use of natural resources.

IPW Europe declares that this product complies with the following European directives: R&TTE (1999/5/EC), LVD (2006/95/EC), RoHS (2011/65/EU), EMC (2004/108/EC) and Battery (2006/66/EC). The corresponding Declaration of Conformity may be viewed upon request.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

CE FC markings are present.

The Remote Control

The remote control allows you to manage the lamp's functions.

Illustration of the remote control with buttons for Candle, Auto, Colour, Intensity, and OFF. A battery compartment is also shown.

Remote Control Functions:

• Candle: Activates the candle effect mode.
• Auto: Gradually changes LED colors.
• Colour: Select the desired color.
• Intensity: Choose between three intensities of white light.
• OFF: Turns off the lamp.
• Lock: Temporarily stops the changing of colors.

Battery Replacement: If the lamp no longer responds to the signal from the remote control, replace the original battery with a new 3V CR2025 lithium battery.

Illustration shows the battery compartment labeled "BATTERY COMPARTMENT OPEN/CLOSE" and "COMPARTIMENT A PILE OUVRIR/FERMER" and "BATTERIEFACH ÖFFNEN/SCHLIESSEN", indicating a CR2025 battery.