TOA DATA Library
User Guide for TOA models including: NF-2S, Window Intercom System, NF-2S Window Intercom System, Intercom System
NF-2S 1CE - Produkte - TOA Electronics
File Info : application/pdf, 2 Pages, 135.32KB
DocumentDocumentWINDOW INTERCOM SYSTEM NF-2S Follow step - to install Window Intercom System. For information on Safety precautions, please refer to the instruction manual. Connect devices. Position the two Sub-Units at speaker face height. Adjust the Base Unit sound volume. Sub-Unit (bottom) When mounting to a partition, use the Sub-Units' built-in magnets to sandwich (mount on either side of) the partition. The recommended settings for the volume controls are as follows: Base Unit (rear) Dedicated cable (accessories) Magnets (2 places) Sub-Unit Recommended volume control settings Hospitals and other quiet locations Locations with ambient noise, such as supermarkets To AC mains Power cord* AC adapter* (accessory) (accessory) * Not supplied with the version W Headset switch Note When using a headset, set the Base Unit's headset switch to ON. Sub-Unit Base unit (front) MIC MUTE buttons Notes When the Sub-Units are positioned too far away from the speaker whose voice may not be picked up accurately. (Refer to the page on the back.) To prevent howling, mount the Sub-Units at least 15 cm away from the edge of the partition. Notes Avoid setting the volume too high, as howling could result. When no sound is being output, check if: · The MIC MUTE button is switched ON. · All connection cables are not firmly connected. Convenient Tool The label of Speak Here is for Sub-Units Download the template provided on the TOA DATA Library to create new label. https://www.toa-products.com/international/detail.php?h=NF-2S Continues on the reverse side. If the speaker is too far from the Sub-Unit: Normally, the distance between the speaker's mouth and the Sub-Unit should be between 20 50 cm. If this distance is greater, there are two things that can be done: [Change the mounting position of the Sub-Units] Even if the Sub-Units cannot be mounted to the partition, they can be installed in appropriate locations using the supplied metal plates. Magnets (2 places) Metal Plate (accessory) Sub-Unit To mounting position [Use a commercially available stand] The Sub-Units can be installed in closer proximity to the speaker(s) with the use of commercially available stands or the like. For Increased Privacy: Sound can be prevented from being heard outside the periphery of the Sub-Units by setting the Base Unit's rear panel LOW CUT switch to ON. Muting sound output with an external switch Sound can be muted as desired by connecting a commercially available switch or similar device to the external control input terminal of MUTE IN. For details, please read the instruction manual. Base Unit (rear) LOW CUT switch External control input terminal For cable arrangement: Cables can be neatly arranged during installation by using the supplied mounting bases and zip ties. Sub-unit Mounting base (accessory) Zip tie After securing the cables, (accessory) cut the zip ties at the base. Partition The instruction manual can be accessed on the TOA DATA Library. Download the manual from QR code* with smartphone or tablet. "QR Code" is registered trademark of DENSO WAVE INCORPORATED in Japan and other countries. 133-21-00654-00