User Manual

Wireless Charger

A diagram shows a rectangular wireless charger with a textured, grid-like top surface, designed for placing a mobile phone. It has connectors on the underside.

Using the Wireless Charger

Ensure your phone supports wireless charging. Place the phone screen-up in the center of the panel to charge. The charging frequency is 110~148KHz. Only one mobile phone can be charged at a time, with a maximum charging power of 15W.

Warnings

• Avoid placing debris on the charging panel, as it may affect charging efficiency or cause failure to charge.
• Metal foreign objects (such as coins and paper clips) can interfere with the wireless charging function.
• Do not place metal objects on the charging tray.
• If your phone has a metal ring, it may affect charging.
• Do not place food or small items on the charging panel to prevent them from falling into the wireless charging fan, which could affect performance.
• The phone's temperature may rise during charging. Do not block the air outlet on the panel, as this affects heat dissipation.
• It is strictly forbidden to place inflammable and explosive materials in the loading tray.
• To avoid mutual interference, do not place car keys on the charging tray while charging.
• Do not place cards with chips (such as bank cards, highway toll cards, etc.) on the wireless charging rack, as this may cause degaussing damage to the card.

Matters Needing Attention

While wireless charging can be installed on the back of your phone, due to varying product quality on the market, compatibility with our wireless chargers is not guaranteed. Therefore, it is not recommended to use wireless charging on this vehicle after adding such accessories to the back of your mobile phone. The manufacturer is not responsible for any resulting consequences.

Specifications

Declarations and Compliance

EU Declaration of Conformity

Foryou Multimedia Electronics Co., Ltd. hereby declares that the radio equipment type, WIRELESS CHARGING MODULE, is in compliance with Directive 2014/53/EU and Equipment Regulations 2017 (S.I. 2017/1206). The full text of the EU Declaration of Conformity is available at the following internet address: www.AdayoMe.com.

Radiation Exposure Statement

This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator and your body.

In accordance with Article 10.2 in Directive 2014/53/EU(RED), this device can be operated in at least one Member State without infringing applicable requirements on the use of radio spectrum.

FCC Statement

Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device must not be co-located or operating in conjunction with any other antenna or transmitter.

FCC RF Radiation Exposure Statement Caution: To maintain compliance with the FCC's RF exposure guidelines, place the product at least 20cm from nearby persons.

IC Statement

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

This Class B digital apparatus complies with Canadian ICES-003.

CAN ICES-003 (B)/NMB-003(B)

This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.