User Guide for BLEND-IN models including: 8720589035010 Portable Rechargeable Blender, 8720589035010, Portable Rechargeable Blender
2022-05-04 — Blending function:Press the switch and hold for 2 seconds. The blender will start automatically and the white light will be on. After 45 seconds the machine.
File Info : application/pdf, 6 Pages, 1.27MB
DocumentDocumentUsing safety Operations Guide 1. Avoid blending with hot liquids. Cracks can occur due to the pressure generated by the steam in an enclosed space. please let hot liquids cool down first. 2. Be careful when using water, for example when cleaning the blender. It is an electrical appliance and water can cause a short circuit. 3. After receiving the blender. Please fully charge the battery before using it for the first time so that it can function at full power immediately. Product Information -01- -02- -03- -04- Model:GN-A04 Valume:370ml Battery specification: 800mAh X 2 7.4V Rated current: 17A Rated voltage: 7.4V Motor specification: 7.4V Rated power: 126W Motor rotating speed:16500rmp/min 15% Glass jug Blade Blade base Switch Charging port Indicating light explanation 1.Blending function:Press the switch and hold for 2 seconds. The blender will start automatically and the white light will be on. After 45 seconds the machine will stop automatically. 2.Crush ice function: Add some fruits & ice & water and press twice quickly. The blender will started automatically and the white light will be on.Then shake the blender and press stop if you see the fruit juice is ok. 3.When connected to a USB charging lead, the red light will be on. When the machine is fully charged and ready, the white light will be on. 2.OPERATION Battery capacity is 1600mAh,please use USB lead for charging connected to an adapter(2A or below 2A), No Fault phenomenon Fault analysis Solution 1 The red light flashes 5 times but the machine doesn't work. The container is not correctly installed on the base. The machine doesn't work 2 and the red light is flashes 10 times. Battery quantity is not enough or no power. 3 The machine stops during operation. Too little food or too much.Either will cause the machine to stop for pro- tection. 4 The red and white light will flash 10 times during operation. The motor has locked. Please re-install again. Please re-install again. Reduce some food and then start again. If there isn't any food blockage, please re-start again. 5 Leaking water. The silicone part is not installed correctly. 6 There is some smoke when using. Long time using, the machine is over heated and protected automatically. Please re-install silicone part. Please cool down the machine for 30-60 mins and then start again. Important WARM REMIND: 1.There will be an error if your glass jug is damaged.Please stop the machine immediately and unscrew the jug if there is leaking,loose screws or malfunction. 2.It is best to charge the machine for between 3-5 hours. 3.The best blending performance is 100g food+200g liquid ( 10%). 4.The machine should only be used when water,milk or other liquids are inside the container at a height above and covering the blades.If food does not blend,add more liquid. 5.Do not wash the base of the machine with water.Do not submerge the base in water.If water is allowed into the switch or charging port,the machine will be damaged. 05