WWB222324 Watch Winder Motor Replacement
Instructions to replace winder motor and gear...
Written By: easy_source
Introduction
This guide provides instructions for replacing the motor and gear assembly of the WWB222324 Watch Winder.
Tools Required:
- Phillips #0 Screwdriver (1)
Parts Required:
- Watch Winder Motor & Gear Assembly (1)
Step 1: Prepare the Winder
Before starting, ensure the watch winder is turned off and unplugged from the power source.
Image Description: The exterior of a wooden watch winder unit is shown. A power switch is visible on the back, along with a power port for the AC adapter.
Step 2: Access the Turntable Platform
Pull the angled turntable platform towards you by its upper seam to detach it.
Image Description: The interior of a watch winder is shown, containing two watch cushions. An arrow indicates the direction to pull the turntable platform.
Step 3: Disconnect Motor Cable
Unplug the motor connection cable from the circuit board.
Image Description: The internal electronics of the watch winder are visible. A motor connection cable is shown plugged into the circuit board.
Step 4: Remove Components
- Unscrew the two retaining screws securing the gearbox.
- Remove the round watch insert.
- Unscrew the single retaining screw from the cup that holds the motor.
Image Description (Left): The underside of the turntable base is shown. A gearbox is attached with two visible screws.
Image Description (Right): The underside of the turntable base is shown, focusing on the central cup. A single screw is visible in the center of the cup.
Step 5: Remove Motor and Reassemble
Pull the gearbox and motor assembly out from the back of the turntable platform.
To reassemble your device, follow these instructions in reverse order.
Image Description: A watch winder motor and gear assembly is shown on the left, and the base of a watch winder turntable is shown on the right. An arrow points to a central screw hole on the turntable base.
