John Deere EZtrak Z200 / ZTrak Z300 Boarding Step Installation Instructions
Document ID: ST50617 | Date: 06/06/2022 | Manual ID: LP66653
Product Compatibility
This kit is compatible with EZTrak Z200 (2015 and prior) and ZTrak Z300 (2016 and later) series mowers.
Parts in Kit
| Parts Description | Qty | Hardware Bag | Qty |
|---|---|---|---|
| Platform (A) | 1 | 3/8" x 2 1/2" Flange Bolt | 4 |
| Clamp Plate (B) | 1 | 3/8" Flange Nut | 4 |
NOTE: Retain these installation instructions with the machine operator's manual.
Installing
Parking Safely
- Stop machine on a level surface.
- Disengage mower blades.
- Move motion control levers out to the Start/Shutdown position.
- Lock the park brake.
- Stop the engine.
- Remove the key.
- Wait for engine and all moving parts to stop before you leave the operator's seat.
- Disconnect the negative battery cable or remove the spark plug wire (for gasoline engines) before servicing the machine.
Installation Procedure
- Use 3/8" x 2 1/2" flange bolts and 3/8" flange nuts to attach platform (A) and clamp plate (B) to the left side frame rail underneath the foot rest. Hand-tighten bolts.
- Confirm Boarding Step is level front to back and clears frame, deck, and front wheel assembly components.
- Use a wrench to hold flange nuts on the inside of the mower while tightening flange bolts on the outside.
Operation
Board the vehicle as listed in the vehicle owner's manual or from the left side by utilizing the boarding step.
[Diagram Description: An illustration shows the boarding step (labeled A) attached to the left side of a mower frame using a clamp plate (labeled B) and bolts.]
Warranty
Limited Warranty for New John Deere Licensed Products
Agri-Fab's Boarding Step is guaranteed to be free from defects in material and workmanship from the date of purchase for 2 years residential use, 6 months commercial use, provided that the purchaser properly assembles, installs, uses and maintains the products in accordance with this manual.
Purchaser's failure to adhere to such requirements will void the warranty. To the extent permitted by applicable law, all other warranties, representations, obligations and conditions, expressed or implied, including but not limited to implied warranties of merchantability, fitness for any particular purpose and non-infringement, are hereby disclaimed and excluded.
Any product which does not meet warranty shall, as purchaser's sole and exclusive remedy, be repaired or replaced by Agri-Fab. This warranty is non-transferable.
In addition, our warranty does not cover:
- Labor charges
- Loss or consequential, incidental or special damages of any kind
This product was manufactured by Agri-Fab, Inc, a John Deere Licensee, located at 809 S Hamilton Street, Sullivan, IL 61951. If you have any questions or concerns with the assembly, installation, or operation of this attachment, see your local John Deere dealer or call Agri-Fab at 1-800 448-9282 for assistance.
[John Deere Logo]
LICENSED
