Instructions for RAB models including: SML2, SML3, SML4, SML3 Surface Linear, SML3, Surface Linear, Linear
local codes. Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
INSTRUCTIONS SURFACE LINEAR INSTALLATION SML2 SML3 SML4 IMPORTANT TO PREVENT ELECTRICAL SHOCK, POWER SHOULD BE TURNED OFF AT THE FUSE BOX BEFORE INSTALLATION. SAFETY WARNINGS: Read all product labels and directions. input rating of the luminaire. local codes. Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation. · WARNING To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects. · INSTALLATION SHOULD ONLY BE PERFORMED AFTER POWER TO THE FIXTURE HAS BEEN DISCONNECTED. · These instructions shall be included on an information sheet packaged with each unit. · This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause try to correct the interference by one or more of the following measures: --Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Consult the dealer or an experienced radio/TV technician for help. WHAT'S IN THE BOX TOOLS NEEDED Installation with J-BOX A screw driver is needed for installation Fixture (1) Nut (1) Long Screws (2) Short Screws (2) Bracket for SML2 Bracket for SML3 SML4 INSTRUCTIONS SURFACE LINEAR INSTALLATION INSTALLATION WITH BRACKET 1. Turn-off/disconnect power at circuit breaker. Attach connector (provided) to AC cable from junction box. 2. Align the hole on bracket to the hole on J-BOX. Use pen to mark holes on ceiling. (Fig.1) Fig: 1 INSTALLATION WITH BRACKET (cont'd) 5. Attach the bracket to junction box using 2 short screws (provided). Pull the AC cables through the bracket center hole. (Fig.4) Fig: 4 3. Drill 12mm holes. (Fig.2) Fig: 2 Drill 12mm hole 4. Align the bracket to final position (angle). Mount 2 long screws (provided) in ceiling through the bracket. (Fig.3) Fig: 3 6. Select desired CCT. Slide safety wire into slot of bracket. Rest product on safety wire while doing eletrical installation. Do not disconnect safety wire after installation. Make wire connections between fixture and junction box with wire nuts (provided). (Fig.5) Fig: 5 7. Lift fixture up against bracket. Slide to locked-sign to lock fixture in place. Remove label. (Fig.6) Fig: 6 v INSTRUCTIONS SURFACE LINEAR INSTALLATION BRACKET DIMENSIONAL DRAWINGS Bracket for SML2 30 480±1 58 70° Ø75 Ø10.6 Ø4.5±0.1 Ø84 Ø94 450 1.5 4 Ø65 30 ØØ6755±±0.3 0.3 0.3 Ø94± 136 Ø5 30 4 Bracket for SML3 SML4 Ø84± 0.3 Ø4.5±0.1 58±0.3 610 640 Easy Answers 2025 Cranbury, New Jersey 08512 USA SMLINFA-IN-0222 P-101364Adobe PDF library 15.00