Blackhawk USB100v2 JTAG Emulator

for Entry-level Debugging at Ultra Low Cost

What's Included

USB100v2 Emulator (with 5 inch, 20-pin CTI JTAG Ribbon Cable)
20-pin CTI to 14-pin TI JTAG Pin Converter
USB Cable
Quick Start Guide
Warranty and Product Registration Information

The Blackhawk USB100v2 JTAG controller is a very low-cost controller for basic debugging of Texas Instruments DSPs. Requiring no external power source, the USB100v2 can support most of the basic features of higher priced emulators and requires no additional drivers when installed using CCS v4 or later. The USB100v2 is a TI XDS100v2-compatible emulator fully supported under CCS v4 and future Texas Instruments roadmap software development environments. Blackhawk's USB100v2 provides additional features and performance not found in other XDS100v1 emulators. The USB100v2 provides for faster code downloads and assembly code stepping in that the USB100v2 uses a high-speed USB2.0 (480 Mb/s) port instead of slower USB1.x (12 Mb/s) implementations. Measuring just 1.6"L x 0.80"W x 0.65"H (4.6cm x 2.0cm x 1.5cm), not including the 5 inch cable, the Blackhawk USB100v2 is the smallest and most compact emulation product from a US manufacturer and is fully assembled and tested in the USA. Blackhawk Advanced JTAG Emulators are available from a worldwide network of industry resellers and distributors.

Product Image Description

The product image shows the Blackhawk USB100v2 JTAG Emulator connected to a ribbon cable, with a "READY" indicator illuminated. The device is compact and designed for debugging Texas Instruments DSPs.

Features

High-speed USB 2.0 Host Interface
Native 2x10 20-pin compact CTI header
1.8/3.3 volt device I/O support
Includes 2x7 14-pin JTAG adapter
Compatible with Code Composer Studio v3.3 and later
Power Status LED
Driver support for Windows® and Linux
Support for "JTAG reset"/"wait-in-reset" boot-modes using the two EMU pins sampled by the nTRST pin.
Support for "Power-on reset" boot-modes using the two EMU pins sampled by the TVD pin.
Debug features: Emulation Connect/Disconnect, Read/Write memory, Read registers, Load program, Run, Halt, Step, Software and Hardware Breakpoint support, Real-Time Mode

Supported Texas Instruments Devices

¹ Support for certain devices may require newer versions of CCS - check the CCS release notes for details.

TI DSP Families

TMS320C28x
TMS320C54x
TMS320C55x
TMS320C674x
TMS320C64x+
TMS320C66x
ARM9

ARM Cores

ARM Cortex A8
ARM Cortex A9
ARM Cortex A15
ARM Cortex R4
ARM Cortex R5
ARM Cortex M3
And More

Includes Texas Instruments Design Network logo representation.

Ordering Information

Blackhawk Part Number: BH-USB-100v2D

For more information, or to order this product online, please visit our website at www.blackhawk-dsp.com.

Learn More

For more information about Blackhawk products, please visit www.blackhawk-dsp.com.