Instruction Manual for VISUAL COMFORT models including: IKF2360, IKF2360 Small Reflector Sconce, Small Reflector Sconce, Reflector Sconce, Sconce
Mafra Small Reflector Sconce
il y a 3 jours — Carefully remove all parts from the box. Place on a clean, soft surface. 2. Remove mounting plate (B) from fixture by removing set screws (F).
Index of /files/vc/
ASSEMBLY INSTRUCTIONS H I L J F G Diagram 1 E C D B KA Mafra Small Reflector Sconce Item # IKF 2360 NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved. TOOLS REQUIRED (NOT INCLUDED): Phillips Screwdriver Hammer Slotted Screwdriver Drill Pencil 1. Carefully remove all parts from the box. Place on a clean, soft surface. 2. Remove mounting plate (B) from fixture by removing set screws (F) using provided screwdriver (G). 3. Using the mounting plate (B) as a guide, line up with the junction box and mark anchor positions. 4. Using a drill bit slightly smaller than the anchor, drill holes in the marked positions. Install anchors (A) into the holes using hammer. 5. Connect driver (K) input neutral wire (white) to the supply neutral wire (usually white) using wire nut (E). 6. Connect driver (K) input hot wire (black) to the supply hot wire (usually black) using wire nut (E). CAUTION: Do not reverse the hot and neutral connections. 7. Insert driver (K) into junction box. 8. Install mounting plate (B) to junction box and secure with mounting screws (C), then secure wood screws (D) to anchors (A). 9. Connect supply ground wire (usually green or bare copper) around the green grounding screw (see diagram 1). Tighten. NOTE: It is imperative that the fixture is grounded. 10. Connect fixture neutral wire (black) to the driver (K) output neutral wire (black) using wire nut (E). 11. Connect fixture hot wire (red) to driver (K) output hot wire (red) using wire nut (E). CAUTION: Do not reverse the hot and neutral connections. ASSEMBLY INSTRUCTIONS H I L J F G Diagram 1 E C D B KA Mafra Small Reflector Sconce Item # IKF 2360 NOTICE: This light fixture should be installed in accordance with all applicable, local installation codes, and by a person familiar with the construction and operation of it, as well as the hazards involved. Inspect item and contents carefully. If any damage or defect is found, do not install. Retain all packaging material until installation is complete and approved. 12. Make sure all wire connections are tight, then carefully tuck into the junction box. 13. Install fixture to mounting plate (B) and secure with set screws (F) using provided screwdriver (G). 14. Remove protective cover (L) from socket. 15. Install LED bulb (I) to socket. 16. Thread shade (H) to fixture body (J). NOTE: Do not overtighten otherwise shade could become damaged. Care Instructions: Clean only with a soft dry cloth or feather duster. Do not use abrasive or chemical agents.Adobe PDF library 15.00 Adobe Illustrator(R) 24.0