2Boom BX550 LED Flame Light Speaker

GETTING STARTED:

Remove the unit from the box. Remove any packaging from the product. Please retain all packaging until you have checked and counted all the parts and the contents against the parts list.

HOW TO CONNECT BLUETOOTH:

Turn on the speaker unit and the Bluetooth switch on your mobile or other device and search for the speaker model name "2BOOM-BX550" and Pair the device. Once device is paired it will automatically connect when unit is turned on subsequently.

CHARGING:

Plug the USB cable into the speaker's charging port and connect to the power source. The red LED indicator on panel will be on when the unit is charging. And will be off once fully charged.

TRUE WIRELESS STEREO FUNCTION:

If you have 2 units for BX550 speaker, turn on both units, and double press the "II" button. You will hear "BEEP" sound and units will connect with each other automatically. Double press the "II" button again to cancel TWS connecting. Note: True wireless stereo function only.

OPERATION:

The speaker has the following controls and ports:

• 1. Power ON/OFF: Controls the power state of the speaker.
• 2. MODE/LED: Short press to switch between Bluetooth, USB, TF, and FM modes. Long press to change 5 light modes and turn the light ON/OFF.
• 3. M4/V-: Short press to play the previous song/channel. Long press to decrease volume.
• 4. HI/SCAN: Long press to PLAY/PAUSE in BT mode and to search for channels in FM mode. Double press to connect TWS function and double press again to cancel.
• 5. /V+: Short press to play the next song/channel. Long press to increase volume.
• 6. AUX Input: 3.5mm AUX Input for audio connection.
• 7. MIC Input: 6.5mm Microphone Input.
• 8. USB Driver: Port for USB drives.
• 9. TF card Slot: Slot for TF cards.
• 10. DC 5V charging port: Port for charging the device.

FCC Statement:

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement:

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Manufacturer Information:

Migear International Group LLC,
21 W 38th Street, 14th Floor, NY, NY 10018 USA
TEL: 929-390-4504