Codelocks KL1100 KeyPad - Installation Instructions & Template

INSTALLATION

Please read carefully:

Before installing the lock, read the programming and operating instructions suited to your KL1100 model. Please note, the KL1100 RFID requires a Master Card to be assigned on powering up. Instructions can be found at: www.codelockssupport.com. Your KitLock is supplied with the powered latch in the unlocked position. If you are installing without loading the batteries, the lock will remain unlocked. The lock is supplied ready to fit doors up to 25mm (1") thick. It is designed for new installations. If replacing an existing key cam lock, the hole may be left exposed by the positioning of the powered latch. A cover plate can be used to hide the hole. Ensure the plate does not increase the door thickness to over 25mm (1").

Box Contents

• Front Plate x 1
• Latch x 1
• Foam Gasket x 1
• Fixing Screws x 2
• Latch Keep/Strike x 1

Installation Diagram

Refer to the installation diagram for visual guidance. Key components include the Front Plate, Latch, Foam Gasket, Fixing Screws, and Latch Keep/Strike.

NEW INSTALLATION

1. The powered Latch Unit is supplied handed to suit a cabinet door with hinges on the right. The latch can be reversed to suit left-hand hung doors.
   a) To reverse the latch, remove the central screw (A) and lift the powered latch, turn through 180 degrees. Ensure cables are not trapped when replacing and securing the latch.
2. Apply the self-adhesive gasket to the back of the KL1100, centering the top hole on the top fixing hole.
3. Remove screw (B) and the battery cover to expose the top fixing hole.
4. Position the Latch Unit against the inside of the door to determine the latch position, accounting for rebated frames and the strike plate. Mark the top fixing hole through the battery compartment and the bottom fixing hole through the Latch Unit.
5. Apply the template with the 6mm (") fixing holes centered over the marked positions. Mark the 19mm (") cable hole.
6. Drill a 6mm (") hole for the fixing holes and a 19mm (") hole for the cable hole. Drill from both sides to prevent splitting the door face.
7. Place the Latch Unit against the door and insert one fixing bolt fully through the top fixing hole and door.
8. Count the number of threaded break-off sections projecting through the door; only one break-off section can enter the KL1100.
   a) If necessary, cut or break off excess sections.
   b) NOTE: Fixing bolt length should be door thickness plus no more than 13mm (").
9. Align the Latch Unit with the fixing holes, pass the control cable through the cable hole. The top fixing bolt can be used to hang the Latch Unit.
   a) NOTE: If removing the lower latch section, take care not to damage the latch power cable.
10. Connect the power cable to the front plate, ensuring the connector is inserted correctly. Refer to the Installation Diagram.
11. Secure the KL1100 and Latch Unit together using the two fixing bolts, ensuring the control cable is not pinched. Feed excess cable back through to the back plate.
12. If fitting the strike plate, power up the lock to ensure engagement without binding and that the powered latch self-closes.
13. If ready to initialize, install the 4 x AA cell batteries and re-attach the battery cover using Screw (B).
14. Proceed with the operating instructions suited to your KL1100 model at: www.codelockssupport.com. Previously programmed settings and registered users will remain. Time and Date will need to be reset. Auto-Unlock settings will remain programmed.

TEMPLATE

Important!

When printing templates, ensure print settings are at 100% of actual size. Check template measurements with a ruler before drilling.

Open Template PDF