Important Information
Make sure the mounting surface is level. Brackets must be in line and level for shade to operate properly. Shim brackets if necessary.
1. Install the Brackets
Diagrams illustrating bracket placement for Inside Mount (IB) and Outside Mount (OB). For IB, brackets are shown mounted on the inside of a window frame. For OB, brackets are shown mounted on the outside of a window frame.
Inside Mount (IB)
Install each bracket with two screws either through the side or up through the top. Make sure all brackets are leveled and aligned.
Outside Mount (OB)
Secure each bracket with two screws. Make sure all brackets are level. Minimum 1 1/4” mounting surface height requirement.
2. Install the Shade
Diagram showing the shade installation process. Step 1: Insert the spring-loaded pin end into the round hole of the bracket. Step 2: Insert the hooks on the clutch into the two slots in the bracket. Step 3: Gently pull downward on the clutch side until hooks lock securely, with the bottom of the clutch pointing straight down.
First, place the spring loaded pin end into the round hole of the bracket. Then, keeping the pin end secure in its bracket, insert the hooks on the clutch straight into the two slots in the bracket. Once the two hooks are through the slots, gently pull downward on the side with hooks until the hooks have locked securely to the bracket. The bottom of the clutch should point straight down.
3. Install the End Caps
(For Open Roll Tubes 1 1/8" to 2 1/2”)
Diagram illustrating the installation of end caps onto the roller tube. The end cap is shown being pushed onto the tube until it clicks into place.
Push the end caps onto the roller tube until they click securely.
4. Removing the Shade
Diagram showing the shade removal process. Step 1: Gently lift the control unit (hooks end) to disengage. Step 2: Slide the roll towards the spring-loaded pin end until hooks are out of the bracket slots. Step 3: Remove the spring-loaded pin end from the idler bracket.
First, raise the shade. Gently lift up the control unit (hooks end) to disengage, until the hooks touch the top part of the bracket slot. Then, slide the roll towards the spring loaded pin end until the hooks are completely out of the bracket slots. Lastly, remove the spring loaded pin end from the Idler bracket.
Child Safety
Young children can STRANGLE in cord loops and in the loop above the cord stop. They can also wrap cords around their necks and STRANGLE.
- Always keep cords out of children's reach.
- Move cribs, playpens and other furniture away from cords. Children can climb furniture to get to cords.
- Do not tie cords together.
- Make sure cords do not twist together and create a loop.
WARNING / ADVERTENCIA
Window Blind Cord Strangulation Risk
Window blinds with a damaged or loose tension device or retractable cord that fails to fully retract pose a strangulation risk to children. To avoid this potential strangulation risk, consider purchasing cordless products or products with inaccessible cords.
Riesgo de Estragulamiento en Cuerdas de Persianas
Las persianas con un dispositivo tensor suelto o dañado o con una cuerda retráctable que no se ajusta completamente representan un riesgo de estrangulación para los niños. Para evitar un posible riesgo de estrangulamiento, considere comprar productos inalámbricos o productos con cuerdas inaccesibles.