Installation Guide for AXXESS models including: AXDIVET1, AXVI-VET1, 1997-2004, AXDI-VET1 Corvette Amplifier Interface, AXDI-VET1, Corvette Amplifier Interface, Amplifier Interface, Interface
Metra AXDIVET1 AXVI-VET1 086429432981
File Info : application/pdf, 4 Pages, 565.81KB
DocumentDocumentCorvette Amplifier Interface 1997-2004 INTERFACE FEATURES · Provides accessory power (12-volt 10-amp) · Retains R.A.P. (Retained Accessory Power) · High level speaker input · Retains amplified door woofers · Micro-B USB updatable INTERFACE COMPONENTS · CHEVROLET APPLICATIONS Chevrolet Corvette ...........................................................................................1997-2004 AxxessInterfaces.com © COPYRIGHT 2023 METRA ELECTRONICS CORPORATION AXDI-VET1 INSTALLATION INSTRUCTIONS TABLE OF CONTENTS Connections LD-AX-XSVI-GM5 Diagram................................2 Installation .............................................................3 Programming......................................................... 3 TOOLS & INSTALLATION ACCESSORIES REQUIRED · Crimping tool and connectors, or solder gun, solder, and heat shrink · Tape · Wire cutter · Zip-ties Visit AxxessInterfaces.com for more detailed information about the product and up-to-date vehicle specific applications ATTENTION: With the key out of the ignition, disconnect the negative battery terminal before installing this product. Ensure that all installation connections, especially the air bag indicator lights, are plugged in before reconnecting the battery or cycling the ignition to test this product. NOTE: Refer also to the instructions included with the aftermarket accessory before installing this device. REV. 8/8/23 INSTAXDI-VET1 CONNECTIONS: LD-AX-XSVI-GM5 DIAGRAM Differential Converter (front view) CH4 CH3 TRIGGER CH2 CH1 Differential Converter (top view) Interface OUTPUT INPUT Output Level Adjustments Vehicle Connectors Fuse Holder LD-AX-XSVI-GM5 Radio Connections Red - Accessory power Red - Accessory power Orange - Illumination Black - Ground wire White/Black - Front left speaker White - Front left speaker + Purple - Rear right speaker output + Purple/Black - Rear right output Gray - Front right speaker + Gray/Black - Front right speaker Green/Black - Rear left speaker output - Green - Rear left speaker output + Blue/White - Amp turn on Yellow - Battery wire 2 INSTALLATION With the key in the off position: · Connect the LD-AX-XSVI-GM5 harness into the interface, and then to the wiring harness in the vehicle. PROGRAMMING Attention! If the interface loses power for any reason, the following steps will need to be performed again. Also, if installing an AXSWC connect it after you initialize and test the interface/radio, with the key in the off position. · Turn the key (or push-to-start button) to the ignition position and wait until the radio comes on. Note: If the radio does not come on within 60 seconds, turn the key to the off position, disconnect the interface, check all connections, reconnect the interface, and then try again. · Turn the key to the off position, and then to the accessory position. Test all functions of the installation for proper operation, before reassembling the dash. Note: If using the AXSWC, connect it after you initialize the AXDI-VET1, with the key in the off position. REV. 8/8/23 INSTAXDI-VET1 3 AxxessInterfaces.com © COPYRIGHT 2023 METRA ELECTRONICS CORPORATION AXDI-VET1 INSTALLATION INSTRUCTIONS Having difficulties? We're here to help. Contact our Tech Support line at: 386-257-1187 Or via email at: techsupport@metra-autosound.com Tech Support Hours (Eastern Standard Time) Monday - Friday: 9:00 AM - 7:00 PM Saturday: 10:00 AM - 5:00 PM Sunday: 10:00 AM - 4:00 PM ® KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolling in the most recognized and respected mobile electronics school in our industry. Log onto www.installerinstitute.edu or call 386-672-5771 for more information and take steps toward a better tomorrow. Metra recommends MECP certified technicians REV. 8/8/23 INSTAXDI-VET1