Instruction Manual for Lindab models including: SVK Sealing Clamp, SVK, Sealing Clamp, Clamp
Sealing clamp SVK Assembly When installing the duct system leave an opening that is one or more cm longer than the fitting you may want to remove later on. It is preferable to install the clamp before the fitting, in the direction of air flow, as this increases the likelihood of the fitting not being pushed out at the end, which is only pushed in. In particular, this applies to fittings with a large pressure drop, such as closed dampers. First install the clamp by inserting it from the side of the opening and then pushing it further along the duct past the end so that the opening remains free. lindab | for a better climate Duct Opening Direction of air Fitting Sealing clamp Then install the fitting by inserting it from the side of the opening and then pushing it in the opposite direction along the duct in the same way. A gap then develops between the fitting and the end of the duct. Gap This gap is covered by the clamp by pushing it back a bit. Then lock the clamp by closing the two eccentric locks. Maintenance The sealing clamp normally doesn't requires any maintenance. 2022-06-14Adobe PDF Library 15.0 Adobe InDesign 15.0 (Windows)