PUREMATE 2500W Oil Filled Radiator (Model PM811)

Introduction

Thank you for purchasing the PUREMATE 2500W Oil Filled Radiator. We wish you many years of healthy indoor air with this efficient and effective product.

Safety Precautions

When using electrical appliances, basic safety precautions should always be followed, including the following:

Read and Follow All Instructions Carefully: PLEASE READ THE FOLLOWING INSTRUCTIONS CAREFULLY BEFORE USING THE APPLIANCE.

• Children of less than 3 years should be kept away unless continuously supervised.
• Children aged from 3 years and less than 8 years shall only switch on/off the appliance provided that it has been placed or installed in its intended normal operating position and they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children aged from 3 years and less than 8 years shall not plug in, regulate, and clean the appliance or perform user maintenance.
• CAUTION: Some parts of this product can become very hot and cause burns. Particular attention has to be given where children and vulnerable people are present.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or similarly qualified persons in order to avoid a hazard.
• WARNING: In order to avoid overheating, do not cover the heater. The meaning of the symbol in marking is “DO NOT COVER”.
• The heater must not be located immediately below a socket-outlet.
• Do not use this heater in the immediate surroundings of a bath, a shower, or a swimming pool.
• This appliance is only for household use.
• WARNING: Do not use this heater in small rooms when they are occupied by persons not capable of leaving the room on their own, unless constant supervision is provided.
• This heater is filled with a precise quantity of special oil. Repairs requiring opening of the oil container are only to be made by the manufacturer or his service agent, who should be contacted if there is an oil leakage. Regulations concerning the disposal of oil when scrapping the appliance have to be followed.
• DO NOT USE this heater if it has been dropped.
• DO NOT USE if there are visible signs of damage to the heater.
• Use this heater on a horizontal and stable surface, or fix it to the wall, as applicable.
• WARNING: To reduce the risk of fire, keep textiles, curtains, or any other flammable material a minimum distance of 1m from the air outlet.
• DO NOT attempt to repair, disassemble, or modify the appliance. There are no user-serviceable parts inside.
• CAUTION: If using an extension lead, please ensure you do not exceed the maximum rated running wattage/load of the extension lead.
• Disconnect from mains when not in use or when moving or cleaning.
• The heater is hot when in use. To avoid burns, do not let bare skin touch hot surfaces.
• Allow the heater to completely cool before handling or cleaning it.
• Ensure the heater is in the “0” OFF position and the power cord is unplugged from the electrical outlet before cleaning the heater.
• DO NOT allow water or other liquids to run into the interior of the heater, as this could create a fire and/or electrical hazard.
• DO NOT use any abrasive cleaners or solvents, as heater damage will occur.

Components

The PUREMATE 2500W Oil Filled Radiator features the following components:

• 1. Castor wheels: For mobility.
• 2. Thermostat Dial: To set and maintain room temperature.
• 3. Power Switch Dial: To select heat output levels.
• 4. Indicator Light: Shows when the heater is on.
• 5. Carry Handle: For easy transportation.
• 6. Front Cover: The main body housing the fins.
• 7. Radiator Fins: The elements that heat up and radiate warmth.
• 8. Cord Storage: For neatly storing the power cord.
• 9. 24 Hour Timer: Allows setting automatic on/off times.

The heater is depicted as a vertical, multi-finned radiator unit with wheels at the base and controls on the side panel. The power cord is shown stored at the bottom.

Overheat Protection: If the temperature of the heater reaches too high, the thermostat will automatically switch off the power, and the heater will stop working. Once the heater has cooled, it can be used normally. This may occur during improper use or certain environmental conditions.

Tip-Over Protection: If the heater is knocked over or tipped onto its side, the safety switch will automatically disconnect power. Power will return to normal when the unit has been placed upright onto a flat, even surface.

Assembly

Follow these steps to assemble the castor wheels:

1. Unpack the castor wheels and arc-shaped brackets from the heater packaging.
2. Turn the radiator upside-down on a scratch-free and stable surface to prevent damage to the paint finish or your floor surfacing.
3. Fit the rear wheel base assembly into the fixed U-bolt, then screw the two wing nuts onto the U-bolt tightly.
4. Fix the front wheel base assembly at the bottom of the front panel by two screws.
5. Turn the radiator back upright once the castor wheels have been fitted.

CAUTION: Only operate the radiator when in its normal upright position with the castor wheels fitted to the bottom of the unit.

Operating Instructions

1. Place the heater upright on a flat, steady, and heat-resistant surface.
2. Turn the thermostat dial anti-clockwise to LOW and ensure the power switch is '0' OFF.
3. Insert the plug into a suitable socket.
4. Turn the power switch dial clockwise to the desired power:
   • '•' Low Heat
   • '••' Medium Heat
   • '•••' High Heat

   NOTE: Do not force the knob beyond its normal stop position.

5. Turn the thermostat dial clockwise until you hear a click and the light turns on. Turning the thermostat clockwise will keep the radiator on until the room gets warmer. Turning it anti-clockwise will turn it off until the room has cooled to a lower temperature and then it will switch on. The radiator automatically rotates through an on-and-off cycle to maintain the current room temperature according to the thermostat's setting. It is normal for it to heat up and cool down periodically.

NOTE: IF THE HEATER DOES NOT TURN ON, ENSURE THE TIMER SWITCH IS SET TO 'I'.

6. To turn off the heater, turn the power switch dial anti-clockwise to “0” OFF.
7. Unplug the heater from the electrical outlet when it is left unattended or is not in use.

Timer Function

The heater can be set to turn ON and OFF at the time you want. Before setting a timer, the clock must be set to the correct time. DO NOT turn the clock anti-clockwise. There are 96 segments around the dial, each representing 15 minutes of the day.

The timer dial is circular with segments representing time intervals. A triangular point indicates the current time setting. A timer switch allows activation of the timer function. The diagram shows a current time of 8:00 AM with segments set outwards for a specific period.

Setting the Timer

1. Plug in the heater.
2. Set the power and temperature to the desired setting.
3. Turn the dial clockwise to set the clock to the current time of the day.
4. Push the segments outwards for the period you want the heater on. For example, the diagram shows the heater will turn on between 1 AM to 3 AM.
5. Push the timer switch to the clock symbol.
6. Once you have set the segments for the desired heating period, the heater will cycle on and off according to these settings.
7. Once unplugged, the heater timer will stop and will need to be reset.

NOTE: When you first use the heater, all 15-minute segments should be inwards. To begin using the timer, push the segments outwards that represent the time of the day you want the heater to work. The heater will switch off again after that period has elapsed.

Cleaning Tips

• Clean the exterior surface of the heater by wiping it with a soft, damp cloth.
• Store the heater in a clean, dry place when it is not in use.

CAUTION

• Allow the heater to completely cool before handling or cleaning it.
• Ensure the heater is in the “0” OFF position and the power cord is unplugged from the electrical outlet before cleaning the heater.
• DO NOT allow water or other liquids to run into the interior of the heater, as this could create a fire and/or electrical hazard.
• DO NOT use any abrasive cleaners or solvents, as heater damage will occur.

Specifications

Disposal of this Device

At the end of the product life cycle, you should not throw this machine into the normal household garbage but bring the product to a collection point for the recycling of electrical and electronic equipment. [Recycling symbol with crossed-out bin]

Contact and Online Presence

Manufacturer: Super Tech Health Limited

Address: 129 Shady Lane, Great Barr, Birmingham, West Midlands, B44 9ER, United Kingdom

Website: WWW.PUREMATE.CO.UK

Find us online: [Facebook] [Twitter] [Google Plus] [Pinterest] [YouTube]