Instruction Manual for InCarTec models including: 29-CTUFT02 Fiat Infodapter With Vehicle Setting, 29-CTUFT02, Fiat Infodapter With Vehicle Setting, Infodapter With Vehicle Setting, Vehicle Setting, Setting
29-CTUFT02 FIAT INFODAPTER INSTRUCTION MANUAL ABOUT Infodapter for Fiat 500X 2015> vehicles allows vehicle setting and parking sensor information to be displayed on any aftermarket head unit with rear camera input. The Infodapter also allows the use of the steering wheel controls with almost every steering wheel control compatible head unit on the market. DIP SWITCH SETTINGS See Fig 1. Up = Off, Down = On 1: On = Pioneer head units. Off = All other head units 2: Setting for reverse camera. On = PAL, Off = NTSC. The default setting is Off (NTSC). 3: Resets the display settings back to default. If the display settings have been manipulated in a way that it is no longer possible to make adjustments, change the DIP switch #3 from Off to On and back. This will reset the screen settings to the factory defaults. During this procedure the screen background will change to red. While the background is red, no settings can be made. 4: Not applicable Interface Connections 12 3 4 DIP ON Reverse Camera output to head unit and reverse camera input from optional camera Power Harness Steering Wheel Remote control connector to head unit Dip Switches Not Used 1 Aftermarket head 4 Reverse Camera Input Fig 1. Fig 2. 10 Reverse camera (optional) 9 To car connector 5 ISO Connector 3 Steering Wheel Control Input 2 Infodapter 7 Mute(Grey) 8 Speed Pulse (Pink) 6 Reverse (Purple) 2 Steering Wheel Controls 1Speech Button 2 2 Track Up/Down 1 Fig 3. Configuration Menu To access the menu, push and hold the speech button for 2 seconds (Fig. 3).(if no speech button, pick up can be used) This will enable the configuration menu. To navigate through the menu options use the Track Up/ Track Down buttons. To select a menu Configuration Menu Vehicle Settings Infodapter Settings Language Version < Back · Vehicle Settings Vehicle settings can be adjusted via the menu. All vehicle setup options that were available with the original head unit, are now available through the aftermarket head unit. See the vehicle handbook for more information regarding these features. Vehicle Settings Display Clock Doors and Locks Lights Safety and Driving Assistance Vehicle Off Options < Back · Infodapter Settings o Screen Size/Position Make sure all 4 corner markers are touching the corners of the aftermarket head unit display. Screen Size/Position Horizontal Size Horizontal Position Vertical Size Vertical Position < Back 3 Configuration Menu...continued o Picture Settings Adjust Brightness, contrast and colour saturation. Infodapter Settings Screen Size/Position Picture Settings Preferences <Back o Preferences - Park Assist Version - Select according to the colour configuration of the park assist fitted to the vehicle. Camera Connected - Select Yes if an optional camera is connected. Reverse Priority* - Select which image (Camera or Park Assist) will be shown by default when reversing. The driver can select the desired image by pushing the Source button (Fig.3) while reversing. (*Note this option is only available when Camera Connected is set to Yes) Park Brake Source - Set to Speed, Brake or Always On. Restore factory settings - Reverts all Infodapter settings to factory defaults. (This does not restore vehicle settings) Preferences Park Assist Version 0 Camera Connected Yes Reverse Priority Park Assist Park Brake Source Speed Restore factory settings < Back Legal Information Please consult the relevant road traffic laws governing the country in which this product is being operated. No liability is accepted for material damage, loss or personal injury, directly or indirectly, from installation and operation of this product. This product should only be operated when safe to do so. 4Adobe InDesign 16.3 (Windows) Adobe PDF Library 15.0