Little Tikes RC Dozer Racer

Contents

• A. RC Dozer Racer™
• B. Remote Control

Illustrations are for reference only. Styles may vary from actual contents.

Battery Installation

Before playing, an adult must install fresh alkaline batteries in the car and remote.

1. Using a Phillips screwdriver (not included), remove the screw and battery compartment cover from the underside of the car.
2. Install four (4) fresh 1.5V AA alkaline batteries (not included) in the car. Ensure the (+) and (-) ends face the proper direction as indicated inside the battery compartment.

   Note: Car batteries are layered with two batteries on the bottom layer and two remaining batteries above. Position the ribbon inside the battery compartment as shown before installing batteries. The ribbon will aid in battery removal.

   Battery Compartment (Car):

   Requires 4 x AA Batteries.

   Diagram shows batteries oriented with positive [+] terminals facing upwards and negative [-] terminals facing downwards in a stacked configuration. A ribbon is shown positioned to assist removal.

   1.5V AA/LR6 [+]

   1.5V AA/LR6 [+]

   1.5V AA/LR6 [-]

   1.5V AA/LR6 [-]

3. Install two (2) fresh 1.5V AA alkaline batteries (not included) into the remote. Ensure the (+) and (-) ends face the proper direction as indicated inside the battery compartment.

   Battery Compartment (Remote):

   Requires 2 x AA Batteries.

   Diagram shows batteries oriented with positive [+] terminals facing upwards and negative [-] terminals facing downwards.

   1.5V AA/LR6 [+]

   1.5V AA/LR6 [+]

4. Replace compartment covers and tighten the screws.

Quick Start

For best results, use on a hard, flat surface in a large open area.

1. Turn the car ON (I).

   Diagram shows a switch in the 'I' position, labeled 'ON'.

2. Turn the remote control ON (I).

   Diagram shows a switch in the 'I' position, labeled 'ON'.

   Note: To properly pair the car and remote, turn the car ON first, then turn on the remote. The red light on the remote will blink until paired and then remain solid.

3. Transform the car from racer to dozer mode using the center buttons on the remote control.

   Diagram shows the car in 'DOZER' mode and 'RACER' mode. The remote control is shown with directional arrows and center buttons.

   Drive the vehicle forward by pressing both arrow buttons at once. To turn left or right, press only the left or right arrow button.

Important Information

• Do not play with the unit in the street or in heavily traveled areas with pedestrians.
• Do not stand on, sit on, or throw the car or remote, as this can cause injury and irreparable damage.
• Avoid running the car into furniture, walls, pets, or people to prevent injury and damage.
• Avoid driving the car through water or mud.
• Keep long hair and loose apparel, such as shoestrings, away from the rotating wheels.
• It is recommended to drive the car on hardwood flooring.
• Keep the remote control within range for proper operation.
• If the car is not functioning properly (jams or makes noises), turn the remote and car OFF (O), manually transform the car to the racer position, then turn ON (I) the remote and car again.
• If the car runs slowly, replace the batteries.
• Turn off both the car and remote after use to conserve battery power.
• Wipe the unit clean with a damp cloth. Keep moisture away from the battery compartment.
• Frequency band range: 2.400GHz - 2.480GHz.
• Maximum radio-frequency power: 5dBm.

Battery Safety Information

• Use only size "AA" (LR6) alkaline batteries (6 required).
• Charging of rechargeable batteries should only be done under adult supervision.
• Remove rechargeable batteries from the product before recharging.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
• Ensure batteries are inserted correctly, following toy and battery manufacturer instructions.
• Always remove exhausted or dead batteries from the product.
• Dispose of dead batteries properly: do not burn or bury them.
• Do not attempt to recharge non-rechargeable batteries.
• Avoid short-circuiting battery terminals.
• Remove batteries before placing the unit into storage for a prolonged period.

FCC Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Caution: Modifications not authorized by the manufacturer may void the user's authority to operate this device.

This device complies with Industry Canada license-exempt RSS-210. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.

CAN ICES-3 (B)/NMB-3(B).

Environmental Care

♻️ Let's care for the environment! The wheelie bin symbol indicates that the product must not be disposed of with other household waste. Please use designated collection points or recycling facilities when disposing of the item. Do not treat old batteries as household waste. Take them to a designated recycling facility.

Limited Warranty

The Little Tikes Company warrants to the original purchaser that this product is free of defects in materials or workmanship for one year from the date of purchase (dated sales receipt required). Remedies are limited to replacement of defective parts or the product itself, at the sole election of The Little Tikes Company. This warranty is valid only if the product is assembled and maintained per instructions. It does not cover abuse, accident, cosmetic issues (fading, scratches), or causes not arising from defects. The warranty period is three (3) months for daycare or commercial purchasers.

U.S.A. and Canada: For warranty service or replacement part information, visit www.littletikes.com, call 1-800-321-0183, or write to: Consumer Service, The Little Tikes Company, 2180 Barlow Road, Hudson OH 44236, U.S.A.

Some replacement parts may be available for purchase after warranty expires; contact for details.

Outside U.S.A. and Canada: Contact the place of purchase for warranty service.

This warranty grants specific legal rights, which may vary by country/state. Some jurisdictions do not allow exclusion or limitation of incidental or consequential damages.