Hygger HG-010 Wave Maker User Manual

1. Product Features

• Circulate the aquarium water: Simulates natural currents of bodies of water like rivers or oceans, providing exercise and healthy flow for your tank. It stirs up debris, removes dead spots, and increases oxygen levels.
• Quiet and powerful: Single head creates strong waves quietly and efficiently. The magnetic and suction base reduces noise and protects the glass during operation.
• 360 Degree Rotation: The head rotates a full 360 degrees, offering full control of flow direction for natural water motion.
• Easy to install and use: Simple installation with magnetic holders.
• Suitable for saltwater and freshwater.

2. Product Parameters

3. Product Instructions

Diagram illustrating the components of the wave maker:

• 1. Front cover
• 2. Impeller
• 3. Pump body
• 4. Fixture for magnetic base
• 5. Magnetic base unit
• 6. Suction base

4. Installation

1. Unpack the box and check for the pump and accessories. Contact the seller if any parts are missing.
2. Insert the fixture of the magnetic base into the pump.
3. Apart the magnetic base.
4. Adjust the required angle of the wave maker. Install it at a position 6-8 inches below the water level. Place the magnetic and suction base mount outside the tank.
5. Power it on.

5. Maintenance

Clean the wave maker to ensure its efficient operation.

1. Shut off the power.
2. To clean debris in the pump: rotate the front cover, remove the impeller, wipe the impeller with a soft cloth, and clean the pump with water.
3. Diagram showing maintenance steps: 1. Rotating the front cover to detach it. 2. Removing the impeller. 3. Cleaning the impeller and pump. 4. Reassembling the components.

6. Attention

• Please read the manual carefully before use and follow all instructions.
• If the wave maker is stuck, it needs to be cleaned and reassembled.
• Running dry is not allowed to guarantee the product's performance.
• Please unplug the power before maintenance.
• The temperature range for the wave maker is 32~113°F.

7. Troubleshooting

8. Warning: Basic Safety Precautions

To avoid possible electrical shock, basic safety precautions should be observed including the following:

1. Read and follow this user manual strictly.
2. DANGER: To avoid possible electric shock, special care should be taken. Do not attempt to repair it yourself; return it to an authorized service facility for maintenance or discard it.
3. Carefully examine after installation. Do not plug in if there is water on parts that are not supposed to be wet.
4. Do not use if it has a damaged cord or plug, or if it is malfunctioning or damaged. The power cord cannot be replaced; if damaged, it should be discarded.
5. To avoid the plug getting wet, position the aquarium stand and tank to one side of a wall-mounted receptacle to prevent water from dripping onto the receptacle or plug. A "drip loop" should be arranged for each cord connecting the device to the receptacle. The "drip loop" is the part of the cord below the level of the receptacle or connector. If an extension cord is used, prevent water from traveling along the cord and contacting the receptacle. If the plug or receptacle gets wet, DO NOT unplug the cord. Disconnect the fuse to the circuit breaker supplying power, then unplug and check the receptacle for water.
6. Close supervision is necessary when used near children.
7. To avoid injury, do not touch moving or hot parts.
8. Make sure it is securely installed before using.
9. Read and observe all important notices.
10. If an extension cord is necessary, use one with a proper rating. A cord rated for less amperes or watts than the appliance may overheat. Arrange the cord to avoid tripping or pulling.

Diagram illustrating the "drip loop" concept for power cords to prevent water from reaching electrical outlets. It shows a loop in the cord below the outlet level.

9. Warranty

• 1-year free warranty.
• 1-month free return.
• 3-month free replacement.

10. Disposal

Do not dispose of this product as unsorted municipal waste. It must not be disposed of with domestic waste. Dispose of it at an authorized recycling facility for electrical and electronic appliances. By collecting and recycling waste, you help save natural resources and ensure environmentally friendly disposal.

11. Contact Information

• Website: www.hygger-online.com
• WhatsApp: +12028664104
• E-mail: Mago@hygger-online.com

Thank you for choosing Hygger. Making aquarium keeping easier one product at a time.

If you have any problems or suggestions, please contact us by email before leaving feedback. This is the fastest way to resolve issues. If satisfied, please leave positive feedback to help more customers discover the product.