Instruction Manual for CTA models including: PAD-FPDMDC Digital Password Combination Security Desk, PAD-FPDMDC, Digital Password Combination Security Desk, Password Combination Security Desk, Combination Security Desk, Security Desk, Desk
CTA Digital Universal Security Mount & P PAD-PARAFPDM Tech-America
CTA Digital Digital Password Combination PAD-FPDMDC Tech-America
CTA Digital Desk Mount for Tablet, Printer, Receipt Printer, Monitor PAD-PARAFPDM: Mounting Kits - COLAMCO.com
Digital Password Combination Security Desk Mount w/ Printer Shelf Compartment PAD-FPDMDC INSTRUCTION - MANUAL CONTENTS: A B x1 x1 H x1 M5 Allen Key C x1 I x4 D E x1 x4 M5x12 F x4 M5 Hex Nut K J G x4 M5 x 6 L x1 x1 x1 INSTALLATION: 1. Assembling base A 2. Attaching Base Pads I H x4 G B 1A. Connect base (B) with body (A). Take the body (A) and align the mounting holes. Rotate in (4) screws (G) with provided allen key (H) until securely tightened. 2A. Flip over the now combined base section. Find the base pads (component I) and peel off the sticker to expose the adhesive. Place the foam pads (adhesive face down on base) at the corners and give it a firm press for a few seconds until it's securely attached. 3. Attaching Kiosk Body to Enclosure E H A M5x12 F K X4 M5 Hex Nut X4 3A. Align VESA holes of the enclosure (K) to the VESA holes of the kiosk body (A). Rotate in screws (E) from above using provided tool (H) whie holding hex nuts (F) from behind from within the storage compartment until securely fastened. 888-733-4448 4. Setting up the Foam Adapters 5. Inserting Tablet into Enclosure J L L L K 4A. Identify the double sided adhesives (J). Peel away the backing on both sides. Adhesive four of them behind the foam pieces (L) as illustrated. They are to adhese the foam to the enclosure. Peel away the back on the next four and place them on top of the foam pieces as illustrated. These are to attach the foam to the tablets and ensure security. 6. Setting Up Enclosure 5A. With the enclosure open, insert tablet into the foam adapters (L). Make sure the adhesives have been placed ahead of time or tablet will fall out. Plug your tablet into any cables/wires you have routed to the enclosure. After tablet is secure, close the top and lock into place. **See following page for digital lock usage and setup 6A. Once tablet is inserted, close the front cover securely. 7. Removing Enclosure Back Opening Covers 6B. After, turn the digital lock 90 degrees clockwise. This will lock the tablet in place. 8. Anti-Theft Deterrent Security 8A. Simply insert key (C) into the keyhole. K Turn to unlock and lock storage compartment. C 7A. When installing device into the enclosure, identify where the camera is. Simply remove and pop out the cover prior to mounting or setting up tablet to properly expose camera if needed. 9. Charging the Digital Lock 10. Cable Routing 10A. Fish the wire through the opening at the top through the kiosk body (A) and out the bottom towards the outlet or wherever it needs to go. 9A. Using the charging cord (D), plug into the port of the M digital lock firmly to charge it up. 888-733-4448Adobe PDF library 16.07