GoCubeX Product Information Guide

Overview

This document provides essential safety, handling, disposal, recycling, and regulatory information for the GoCubeX, along with its limited warranty details. Please read all safety and operating instructions before use to avoid injury or harm.

By using GoCubeX, you agree to the terms and policies found at GetGoCube.com/terms, including the Particula Privacy Policy.

Environmental Conditions

Operating Temperature: 0°C to 40°C (32°F to 104°F)

Relative Humidity: 5% to 95% non-condensing.

Using GoCubeX in very cold or high temperature conditions might temporarily shorten battery life and could cause the device to stop working. Avoid exposing GoCubeX to direct sunlight or hot car interiors. Temperatures in parked cars can exceed safe operating ranges. For best results, use indoors. Never expose GoCubeX to water.

Warranty Information

Your GoCubeX purchase includes a one-year limited warranty for the Original Purchaser, covering manufacturing defects. It does not cover abuse, alteration, theft, loss, unauthorized or unreasonable use, or normal wear and tear.

During the warranty period, Particula will make the sole determination of a defect. If Particula determines a defect, Particula, at its sole discretion, will repair or replace the defective part or product with a comparable part. This does not affect your statutory rights.

For full details, safety updates, or support, visit GetGoCube.com/warranty.

Battery Information

Replacing Batteries

Follow these principles when replacing batteries:

• Use only the correct type and size battery indicated.
• Check the contacts of both the battery and the battery-operated product for cleanliness.
• Always insert batteries correctly with regard to polarity (-/+) matching the positive and negative symbols of both the battery and the product.
• Remove and safely dispose of exhausted batteries immediately.
• Keep batteries out of reach of small children.

How to Insert the Coin Cell Battery

To replace the battery, the screw hole must always be on the bottom right corner.

1. Step 1: Position the battery with the screw hole on the bottom right.
2. Step 2: Insert the battery.
3. Step 3: Ensure correct alignment.
4. Step 4: Secure the battery.
5. Step 5: Complete the insertion.

Regulatory Compliance

FCC Compliance

FCC ID: 2AWLXRBE001CC

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Frequency Band: 2402-2480MHz

Maximum Radio-Frequency Power Transmitted: <10 dBm

IC Compliance

IC: 26194-RBE001CC

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s).

Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.

(French Translation) Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux normes Innovation, Science et RSS (s) exempté (s) de licence par Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes : (1) Cet appareil ne doit pas causer d'interférences. (2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable du périphérique.

Declaration of Conformity

Particula Ltd hereby declares that the radio equipment type RBE001-X is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at: https://getgocube.com/compliance

European Union - Disposal Information

[EU disposal symbol] The symbol above means that according to local laws and regulations, your product should be disposed of separately from household waste.

When this product reaches its end of life, take it to a collection point designated by local authorities. Some collection points accept products for free. The separate collection and recycling of your product at the time of disposal will help conserve natural resources and ensure that it is recycled in a manner that protects human health and the environment. Keep these instructions for future reference.