Sensing Solution | Honeywell
Honeywell - The Future Is What We Make ItElectric vehicles sensors | HoneywellCSNV700 Series Flux Gate Current Sensors | HoneywellBES LITE Series | Honeywell
Installation Guide for Honeywell models including: BESL-10100-000, P-DV2-1-022, BESL-10100-000 BES LITE Sensor, BESL-10100-000, BES LITE Sensor, LITE Sensor
6 giorni fa — The BES LITE, available in flange-mount and board-mount versions, is a compact and cost-effective battery electrolyte vapor.
CSNV700 Series Flux Gate Current Sensors | Honeywell
File Info : application/pdf, 1 Pages, 2.92MB
DocumentDocumentBESS SENSING SOLUTIONS FROM HONEYWELL Battery Energy Storage Systems (BESS) store and manage energy, ensuring reliability, efficiency, and integration with renewable sources. These complex units require sensors to ensure safety and monitor battery charge and health. Battery Management Systems Battery Modules The BES LITE, available in flange-mount and board-mount versions, is a compact and cost-effective battery electrolyte vapor detector that is specifically designed for in-pack use. By installing a single BES LITE sensor in each battery pack, you can effectively ensure timely and proactive detection of thermal runaway events. The BES LITE is engineered to detect gases that are typically released during the initial phase of thermal runaway as well as throughout the entire thermal runaway process. · Early Detection: Identifies venting events well before thermal runaway · Timely Alerts: Offers early warning for impending thermal runaway · Selective Sensitivity: Exclusively detects electrolyte vapor for accuracy · Space-Saving Design: Compact design integrates seamlessly into battery packs and BMS boards · In-built Diagnostics: Enabled through three-state analog output Honeywell Sensing Solutions 830 East Arapaho Road Richardson, TX 75081 www.honeywell.com 006025-2-EN | 2 | 05/25 © 2025 Honeywell International Inc. All rights reserved. BESL-10100-000 22124 P-DV2-1-022 = BES LITE Sensor One sensor mounted inside each battery module Honeywell CSNV500 and CSNV700 current sensors are housed within the BESS' battery management system (BMS). The sensors are interfaced with the BMS to help measure the current in the modules. They can also monitor battery charge and health, provide overcurrent protection, optimize power use, extend battery life, managed the load, and ensure safety compliance. · Measures up to 500 A, 700 A, respectively · High accuracy, low-temperature drift · Excellent zero-offset performance · Uses AEC-Q components (CSNV700) · Excellent stability, reliability, and EMC performance · CAN communication