Delphin DIVER9U Electronic Bite Alarm Set User Guide

This document provides instructions for the Delphin DIVER9U electronic bite alarm set.

Product Overview

The Delphin DIVER9U is an electronic bite alarm set designed for fishing, consisting of a receiver and one or more bite alarms. It features multiple volume and sensitivity settings, vibration alerts, and long-range signalisation.

Technical Specifications

Frequency Band: 433.92 MHz

RF Power: 4.42 dBm

Range: Up to 150m (depending on conditions)

Receiver Features

  • 5 levels of volume
  • 4 colourful signalisation LED lights
  • Vibration mode
  • Memory for settings
  • Low battery indication (vibration alert)
  • Power supply: 3x1.5V batteries (AAA type)
  • 10 seconds of illuminating light after the bite

Bite Alarm Features

  • Waterproof
  • 8 different tunes of signalisation (T button)
  • 6 levels of volume + mute mode (V button)
  • 6 levels of sensitivity (S button)
  • Memory for settings
  • Power supply: 1x9V battery
  • 20 seconds of illuminating light after the bite
  • Input for 2.5mm jack

Diagrams and Controls

Receiver Diagram

The receiver features an antenna at the top. Below are rows of signalisation LED lights. Control buttons include ON/OFF, volume adjustment ('-' and '+'), and a speaker at the bottom.

Bite Alarm Diagram

The bite alarm has a colourful LED light at the top. Control buttons are labeled V (volume), T (tune), S (sensitivity), and ON/OFF. It includes a speaker and a 2.5mm jack input.

Operation Manual

Before First Use

To open the receiver, slide down the belt clip, then slide the cover upwards. Insert 3x AAA batteries, observing polarity. To open the bite alarm, slide the back cover down and insert a 9V battery. Replace and secure both covers.

Turning On/Off

Press and hold the ON/OFF button. This is accompanied by sound and light signals.

Pairing Bite Alarm and Receiver

Ensure both devices are powered on. On the receiver, press and hold the '+' and '-' buttons. After a short sound, simulate a bite on the alarm (e.g., with a piece of paper). The alarm should automatically connect and signal the bite on the receiver's LED.

Deleting Pairings

On the receiver, press and hold the '+' and '-' buttons simultaneously until three short beeps are heard. This process takes approximately 6 seconds and clears all paired devices from memory.

Important Warning

If the device is not in use or during transport, remove batteries from both the receiver and bite alarm. Store them separately to prevent short circuits. Before inserting batteries, inspect them carefully for leaks or damage.

Warranty Information

Keep the warranty letter carefully. The model is the Delphin DIVER set, available in configurations like 2+1, 3+1, and 4+1. Record the date of purchase and seller's details. The warranty letter also includes sections for warranty service and post-warranty service.

Declaration of Conformity

The device, Delphin DIVER 9V, manufactured by MOSS.SK, s.r.o., complies with Directive 2014/53/EU and Directive 2011/65/EU. The full text of the declaration of conformity is available at www.delphin.sk.

Models: Delphin, DIVER 9V, receiver

PDF preview unavailable. Download the PDF instead.

diver Adobe PDF library 15.00 Adobe Illustrator 24.0 (Macintosh)

Related Documents

Preview Delphin SMART Bite Alarm Set User Guide
Comprehensive user guide for the Delphin SMART bite alarm set, detailing receiver and bite alarm functions, operation, pairing, and technical specifications. Includes warranty information and EU compliance.