EGO AMG1000 On-Board Storage Installation Guide

Product Overview

This document provides instructions for installing the EGO AMG1000 on-board storage bin and net onto your EGO Power+ Zero Turn Ride-On Mower. It details the components and the assembly process.

Included Components

The installation requires the following main components:

• On-board storage bin
• Storage net
• Various metal brackets and support bars
• Fasteners: Screws of sizes M8*45, M8*55, and M8*70.

Note: Specific quantities of screws are not explicitly listed but are referenced by size in the diagrams.

Installation Procedure

Follow these steps to correctly install the storage accessories:

Part A: Initial Assembly and Bracket Mounting

A1: Correct Installation Visual

An illustration shows the EGO Zero Turn Ride-On Mower with a green checkmark (✔️), signifying a correctly assembled or installed state.

A2: Incorrect Installation Visual

An illustration shows the EGO Zero Turn Ride-On Mower with a red cross (❌), indicating an incorrect assembly or installation.

A3: Identifying Mounting Points

This diagram highlights the rear section of the mower, marking three specific points (labeled 1, 2, 3) where mounting brackets will be attached.

A4: Positioning a Support Bracket

A metal bracket is shown being placed onto a designated area of the mower's frame.

A5: Securing Bracket with Screws

The bracket from step A4 is shown being fastened to the mower frame using screws (likely M8*45 or M8*55) and a tool.

A6: Aligning the Storage Bin

The main storage bin is depicted being positioned and aligned with the mounting locations on the mower.

Part B: Attaching Bin, Supports, and Net

B1: Inserting a Mounting Bracket

A specific metal bracket is shown being inserted into a slot on the mower structure.

B2: Fastening Bracket with Screws

The bracket from step B1 is secured to the mower using screws (likely M8*45) and a tool.

B3: Attaching a Support Handle

A handle or support bar is shown being attached to the mower frame, secured with screws.

B4: Attaching a Second Support Handle

A second handle or support bar is attached in a similar manner to step B3.

B5: Securing Storage Bin with Fasteners

The storage bin is shown being further secured to the mower using additional brackets and screws (likely M8*45 and M8*55).

B6: Finalizing Bin Attachment

The storage bin's attachment is completed by fastening it with screws (likely M8*45) and a tool.

B7: Storage Bin Mounted on Mower

An illustration shows the storage bin fully and securely attached to the rear of the EGO Zero Turn Ride-On Mower.

B8: Detailed View of Storage Bin

A close-up view of the storage bin itself is provided.

B9: Detailed View of Storage Net

A close-up view of the storage net is provided, indicating its design and potential attachment points.

Important References:

The document also references a "BLADE STOP/START KEY" (implied by visual context of a key and text fragments). The screw sizes M8*45, M8*55, and M8*70 are critical for various assembly steps.