Perth Table Assembly Instructions

Parts List

• A: Tabletop (x1)
• B: Leg Frame (x2)
• C: Screws (M8*16mm) (x8)
• D: Washers (x8)
• E: Allen Key (x1)
• F: Support Brackets (x4)

Assembly Steps

The assembly process involves attaching the leg frames to the tabletop using the provided screws and washers. An Allen key is included for tightening the screws. Support brackets are also used to reinforce the structure.

Step 1: Attach Leg Frames

Position the two leg frames (B) onto the underside of the tabletop (A). Align the holes on the leg frames with the pre-drilled holes on the tabletop.

Step 2: Secure Leg Frames

Insert screws (C) through the washers (D) and then through the holes in the leg frames (B) into the tabletop (A). Use the Allen key (E) to tighten the screws securely. Repeat for all eight screw points.

Step 3: Attach Support Brackets

Attach the support brackets (F) to the leg frames as indicated in the diagrams to provide additional stability. Use the remaining screws (C) and washers (D) if applicable for this step.

Step 4: Final Check

Ensure all screws are tightened and the table is stable. The maximum weight capacity for the table is 60kg.

Diagram Descriptions

The first diagram shows the assembled table with a weight of 60kg indicated on top. It also displays icons representing a person, a clock, and weight limits, along with the parts list (A-F) with quantities.

The second diagram illustrates the assembly process, showing how the leg frames (B), screws (C), washers (D), and Allen key (E) are used to attach the leg frames to the tabletop (A). Support brackets (F) are also shown in their placement.