User Guide for POINT Mobile models including: PM351 Industrial Mobile Terminal, PM351, Industrial Mobile Terminal, Mobile Terminal, Terminal, PM351 Industrial Mobile Terminal
Point Mobile PM351 Quick Start Guide | BIAS Technology Support Ltd
Quick Start Guide PM351 V1.0, May 2022 Copyright © 2022 Point Mobile Co., Ltd. All rights reserved. Point Mobile Co., Ltd. is the designer and manufacturer of mobile handheld devices. The Point Mobile logo is a registered trademark and symbol of Point Mobile Co., Ltd. Features and specifications are subject to change without prior notice. Device Parts 1 3 4 6 7 5 2 1. Scanner & Camera 2. LED indicator 3. Touch screen 4. Keypad 5. USB connector 6. Power button 7. Microphone Device Parts 8 9 11 12 13 14 8. Speaker 10 9. Hand strap hole (Top) 10. I/O connector (Rear) 11. Battery 12. Battery release button 13. Hand strap hole (Bottom) 14. I/O connector (Bottom) Product Standard Accessories Battery pack 5V 2A power adapter Battery Replacement Insert Battery 1. Align the battery release button to the bottom side. And insert the battery from the top side of the device. 2. Push the battery down until it clicks, and check if the battery is firmly engaged. AC Plug USB type C cable Hand strap Stylus pen LCD protection film Caution: Make sure the SIM and SD card holders are completely closed before inserting the battery. Remove Battery Pull up the bottom side of the battery while pressing the battery release button. Installing SIM, SD card PM351 supports micro SIM and microSD card. (SIM card is supported by LTE SKU only.) SIM card 1. Gently slide the cardholder up, and swing upwards. 2. Put the SIM card facing down the gold contact. 3. Close the holder down and slide it down to lock. Turning on / off SD card 1. Gently slide the cardholder down, and swing upwards. 2. Put the SIM card facing down the gold contact. 3. Close the holder down and slide it up to lock. Numeric Alpha-Numeric Turn on Press and hold the Power button on the keypad until SMART BEYOND RUGGED logo displays on the screen. Turn off When the screen is on, press and hold the Power button until the power menu is shown. Then, tap Power off among the menu. Charging the Device LED Indicator 1 2 1. Assemble the AC plug, power adapter and USB cable. 2. Connect the cable to the USB connector of PM351. 3. Provide power by plugging the power adapter to the wall socket. PM351 can also be charged with charging cradle (sold separately). < Caution > 1. Always use an original power supply from Point Mobile. Other chargers and cables may damage the PM351. The device warranty does not cover any damage caused by the usage of non-original power supplies. 2. Make sure the charger and cable is not wet. No Indicator Power 1 LED Status Solid green Solid red Blinking red Indication Device is fully charged Charging the device / Battery is low Charging temperature is out of normal range / Battery is very low Alternately blinking Cannot recognize the battery red & green Solid red Device entered hot swap mode 2 Notification Blinking blue LED Red flash Notification existing Barcode reading failed Blue flash Barcode reading success Using Keyboard Backlight Use keyboard backlight when the keypad is not visible in the dark place. 1. Go to Settings > Display 2. Turn the Keyboard Backlight switch on. Scan a Barcode Scanner is placed on the top of the PM351. Scanner is disabled by default, so enable the scanner from ScanSettings first. Then, press a scan button on the device to scan a barcode. Center the aimer (laser bar, green dot, or red dot) over the barcode. SE965 Scanner SKU SE4100 Scanner SKU SE4710 Scanner SKUMicrosoft PowerPoint 2019