SG586-S Installation Guide

Introduction

This document provides essential instructions for the proper installation and mounting of the SG586-S component. It details the hardware required and the steps to ensure a secure and correct fit.

Product Overview: SG586-S

The SG586-S is a component designed for integration into various systems, likely related to electronic speed control (ESC) applications. This guide focuses specifically on its physical mounting procedure.

Mounting Hardware Included

The following hardware is provided for the installation of the SG586-S:

• Flat Head Cap Screw (M3x8mm): Part Number HC134-S. These screws are used to fasten components together.
• SC Plate Mount: A specialized plate designed to interface with the SG586-S and the mounting surface. It may incorporate threaded holes or alignment features.
• Spacer: Part Number H2099-S. This component is used to create a specific distance or clearance between the SG586-S unit and the mounting surface.
• Mounting Plate: Identified by Part Number H1228. This plate serves as the primary interface for attaching the SG586-S assembly to the final structure.

Installation Procedure

Follow these steps carefully to mount the SG586-S component:

1. Prepare the SC Plate Mount: Place the SC Plate Mount onto the intended mounting surface. If the plate has specific orientation markings, ensure they are correctly aligned.
2. Position the Spacer: Place the Spacer (H2099-S) onto the mounting surface or the SC Plate Mount, aligning its holes with the corresponding mounting points. This step ensures proper spacing.
3. Align the SG586-S Unit: Position the SG586-S component over the Spacer (H2099-S) and the SC Plate Mount, aligning the mounting holes of the SG586-S with the threaded holes or features on the SC Plate Mount and the mounting surface.
4. Secure the Assembly: Insert the Flat Head Cap Screws (HC134-S) through the mounting holes of the SG586-S unit and the SC Plate Mount. Thread these screws into the designated mounting points on the surface or the SC Plate Mount. Tighten the screws securely to ensure the SG586-S unit is firmly attached. Avoid overtightening to prevent damage to components.
5. Final Check: Verify that the SG586-S unit is stable and correctly positioned. Ensure all screws are snug.