Drapery Workroom & Upholstery Supplies | Rowley
User Manual for Rowley models including: RTAWR1CV1W, RTAWR2CV1W, RTAWR1CV1W LED Wall Mount Remotes, RTAWR1CV1W, LED Wall Mount Remotes, Wall Mount Remotes, Mount Remotes
File Info : application/pdf, 1 Pages, 460.19KB
DocumentDocumentRTAWR1CV1W & RTAWR2CV1W LED Wall Mount Remotes User Manual I-RTEC3 1. PRODUCT DIAGRAM FRONT LED Up Down Up 2 LED Up 1 Stop 2 Down 2 Stop 1 Down 1 Stop Fav Fav 2 Fav 1 RTAWR1CV1W Single Channel wall remote RTAWR2CV1W Dual Channel wall remote BACK Prg1 Prg2 RTAWR1CV1W & RTAWR2CV1W 2. REMOTE SPECIFICATIONS Battery Type Working Temperature Radio Frequency Transmit Distance CR2430*3V*2 14°-122°F 433.92M+-100KHz >=98.5 indoor 3. CAUTION WARNING: Important safety and operation instructions to be read before installation and use. 1. This product is intended for indoor use only. Do not expose the remote to moisture or extreme temperatures. 2. If the remote becomes less responsive and has a shorter transmission range, please check whether the battery needs to be replaced. 3. Use or modification outside the scope of this instruction manual will void warranty. 4. When the battery voltage is too low, the orange LED will flicker during operation. 5. Please properly dispose of used batteries and replace with only the specified battery type. 4. INSTRUCTIONS Follow the motor pairing instructions for the single channel wall remote. For the dual channel wall remote follow the steps below: Dual Channel Wall Remote pairing only: For pairing a motor(s) with the dual channel wall remote on channel 1: H BUTTON P1 Remote & Motor are now paired Hold the H button on the motor head for 2 seconds Jog x1 Press the Programming P1 button on the remote Jog x2 To add an additional motor B: To add an additional motor to the same channel follow the steps above for motor B. For pairing a motor(s) with the dual channel wall remote on channel 2: H BUTTON P2 Remote & Motor are now paired Hold the H button on the motor head for 2 seconds Jog x1 Press the Programming P2 button on the remote Jog x2 Note: A maximum of 15 motors can be added to one channel. All motors added to the same channel will operate simultaneously. See motor pairing instructions first before completing the following steps below. LOCKING THE REMOTE: Prohibits any programming or settings from being changed on the Remote. Remote is Locked Hold the programming P1 or P2 button for 10 seconds LED flickers x3 To unlock the remote and allow programming once again, repeat the steps above. For further operations please refer to the motor pairing instructions. RowleyCompany.com | updated 06/10/2024