Remote Mount Inlet Air Filter Mounting Instruction

1. Place the Remote Mounting Bracket onto the Inlet Air Filter assembly and align the attachment holes.
2. Fasten the Bracket to the Inlet Air Filter using the two provided screws.
3. Screw the 3/8" NPT (F) x 1/2" Tube Fitting onto the Inlet Air Filter and hand-tighten. Thread tape is not required.
4. Identify a suitable location for the Remote Inlet Filter. Ensure the area is dry, away from heat sources, and that the air inlet slots on the filter are unobstructed and not facing upwards.
5. Drill a 3/8" mounting hole. Push the Remote Filter Bracket pin into the hole.
6. Screw the 3/8" NPT (M) x 1/2" Tube Fitting onto the compressor's air inlet port and tighten with a wrench. Thread tape is not required.
7. Attach the provided 1/2" air line to the barbed tube fitting of the compressor's air inlet port.
8. Route the air line to the Remote Inlet Air Filter, measure, and cut it to the appropriate length. Attach the air line to the Remote Inlet Air Filter.