Instruction for Use

▶️ Product Information

Product name: 2.4G-smart fan light controller

Model: BT004

▶️ Product Parameter Information

• Frequency: 2402-2480MHz
• Modulation: GFSK
• Data rate: 1Mbps
• Channel number: 40CH
• Power Supply: DC 3V
• Battery: 1.5V×2AAA

▶️ Instructions of Product

1. Light on/key: When the lamp is fully lit, press the lamp switch. The sequence of operations is:
   • First press: lights are all off.
   • Second press: the light is white.
   • Third press: the lights are off.
   • Fourth press: the warm light.
   • Fifth press: the lights are off.
   • Sixth press: the lights are all lit.
   If the cycle continues, it repeats the sequence. The buzzer does not sound on time.
2. Brightness +, Brightness - key: When the lamp is on, press the brightness + or brightness - key to adjust the brightness. The buzzer will not ring on time. Long press for non-polar dimming; point press for a plus or minus one pole, with ten poles between maximum and minimum.
3. Color temperature +, Color temperature - key: When the lamp is on, press the color temperature + or color temperature - key to adjust the color temperature back and forth, on time.

Note: There is no sound when the function related to the lamp is operated, and there is a sound when the function related to the motor is operated.

▶️ Safety Caution

1. When using any remote control for the first time, appropriate batteries should be loaded first.
2. Ensure that the LED light of the main control device and the motor device are correctly connected.
3. Check whether the power supply of the main control device is properly connected, and the device is fully powered on and enters the standby state.
4. Then learn the code with the master; the code can be used normally.
5. Finally, select different functions according to the needs.

▶️ FCC Compliance

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• (1) this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired operation.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. The devices have been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.