KARIZMA luce Gaia XS Outdoor Installation Manual

PREPARATIONS

Before assembling the luminaire, carefully read these instructions to make sure the luminaire functions correctly and safely.

This product can be used outdoors and its protection grade reaches IP67 and IK06.
Voltage of this product is safety extra low voltage (SELV), the input voltage is constant DC 24V. Using the wrong input may cause fire, personal injury and product damage.
Working environment temperature: -30°C to +40°C.
Do not install the product under water or soak it in water for a long time.
This product uses a 1-meter long 2x2.5 square rubber cable for power supply. Pay attention to the connection and waterproof treatment.
Turn off the power before any operation.
Improper repair procedures or modification may lead to electrical shock or other bad results.
Replacing parts? Only use replacement parts specified by the manufacturer.

Manufacturer reserves the right to change the product specification without prior notice. Store manual for future reference.

SAFETY WARNING: It is forbidden to use DC or AC power adapters and components with a constant voltage of DC24V to power the product. Do not use any solvent, glue, oil, or high concentration detergent to make it contact with product components.

PLEASE NOTE: Installation must be done by qualified technical professionals!

IP67 CE [Recycling symbol] [WEEE symbol] RoHS [Downward arrow] [Home installation symbol] III 24V

DRIVER (not included!)

Diagram description: Input AC 200-240V connects to an LED Driver, which outputs DC24V to the LED.

Please note! IP rating of the connection material needs to be at least of the same level of the luminaire!

FRONT SIDE

Illustration shows the circular front face of the luminaire.

PROFILE

Illustration shows the side profile of the luminaire, indicating its shape and dimensions.

CONNECTION PREVIEW

Illustration shows the luminaire with its cable, ready for connection.

Visit: karizmaluce.com

DIMENSIONS

Diagram shows the luminaire with a diameter of Ø25mm and a height of 70mm.

Installation Steps

Step 1a: Hole Preparation

Illustration depicts preparing a mounting hole. A circular cutout with a diameter of Ø23mm is shown, with an arrow indicating a rotational or cutting action, suggesting the use of a tool.

Step 1-1, 1-2: Power Switch Detail

Detail shows a toggle switch labeled 'ON' and 'OFF'. A secondary illustration provides a close-up of a connection point or mechanism.

Step 2a: Luminaire Insertion

Illustration shows the cylindrical luminaire being guided into a pre-cut hole in a surface, with a curved arrow indicating the direction of insertion.

Step 3a: Wiring and Installation

Diagram illustrates the electrical connection and physical installation. An AC 200-240V input line connects to an LED Driver, which provides DC24V to the LED luminaire. The luminaire is shown being placed into a surface opening, with its cable being routed through.

Step 4a: Electrical Circuit Diagram

Electrical schematic shows the system's wiring. The AC 200-240V power supply (Line L, Neutral N) is connected to the LED Driver. The DC24V output from the driver is then distributed to three individual lights (L1, L2, L3) wired in parallel.

Step 5a: Installed Luminaires

Illustration shows multiple Gaia XS Outdoor luminaires installed on a surface, emitting light beams upwards, indicating their operational state.

Step 5-1, 5-2: Control Switch Detail

Detail shows a control switch with 'ON' and 'OFF' positions, likely for activating or deactivating the installed luminaires.