Delta FOC+PG Control AC Motor Drivers
Delta Electronics, Inc.
For ordering information, please visit Deltaacdrives.com or call +1(800)985-6929.
Features
- V/F, FOC+PG, SVC, Torque+PG, Position control
- PG close-loop control, speed control range 1:1000
- Built-in PID feedback control
- Motor parameter and load inertia auto-tuning
- 4 independent S-curve/accel/decel time setting
- Mechanical braking release control function
- Deceleration energy braking function
- Motor Y-A switch control
- 10 communication address for block transfer
- I/O serial pulse position control
- Monitor card and software
- Auto energy saving at light load
- Motor overhead protection (PTC function)
- PI gain for zero/low/high speed and bandwidth setting
- Home search, Pulse command and 16 point position control
The Exterior and Characteristics of the Drive
The digital operation panel can be extended up to 20 meters externally using an RJ-11 connection.
The drive can connect with a PG (Pulse Generator) to serve as a closed-circuit speed control system.
KPV-CE01 Digital Keypad Description
- JOG Operation Key: Press to execute JOG frequency operation.
- Left Key: Used to modify settings to greater values.
- Value Modification Key: Used to modify settings and parameters.
- FWD/REV Direction Key: Controls the forward and reverse direction of the motor.
- RUN Key: Enables the drive to start operating.
- LED Display: Shows frequency, current, voltage, and error codes.
- Status Display: Indicates the drive's current status.
- Mode Selection Key: Press repeatedly to cycle through different operational modes.
- PU Key: Used to modify settings to smaller values.
- PROG/DATA Key: Used to read and modify parameter settings.
- STOP/RESET Key: Stops the drive and resets any active faults.
Basic Wiring Diagram
A basic wiring diagram illustrates the connections for the motor driver, including power supply, fuses, control terminals, and motor output.
FOC+PG Control AC Motor Drivers - VFD 037 V 23 A-2
Model Explanation
The model number VFD-VE series indicates the mains input voltage: '23' for 230V Three phase and '43' for 460V Three phase. The 'A-2' denotes the Version Type.
General Specifications
Detailed specifications are provided for various control systems, torque start-up, speed control voltage, motor output, power supply frequency, input current, voltage tolerance, coating method, cooling method, and weight.
460V Series
Specifications for the 460V series are listed, including model numbers, rated output current, and power supply frequencies.
Dimensions
The document provides dimensional drawings (labeled 1, 2, 3) and a table with measurements (A through G) for different frame sizes corresponding to various model names.
Dimensions: 11 units (specific unit not provided in source text)
Weight: 1100 g (3.5 oz)
VFD-VE with 100% Sudden Load
Graphs illustrate the performance of the VFD-VE series under sudden load conditions, showing speed and torque responses with and without PDFF function.
PDFF Function
Details on the PDFF function are provided, with values such as PID: 240 and weight: 100 g (0.5 oz) mentioned in relation to its performance.
Additional Information
Information regarding units without the PDFF function is also available.
Accessories (Optional)
- VFDB Series Braking Unit
- EMI FILTER
- BR-Series Braking resistor
- EMV-PG01X CARD
- EMV-PG010 CARD
- EMV-PG011 CARD
For quote requests, contact info@automatedpt.com. To order, call +1(800)985-6929 or visit Deltaacdrives.com.