mailto:info@airplex.co
Ute, Truck & Car Accessory Manufacturer & Distributor in NZ
Instructions for airplex models including: FIT918 HD Euro Low Roof Cab Sunvisor, FIT918, HD Euro Low Roof Cab Sunvisor, Euro Low Roof Cab Sunvisor, Low Roof Cab Sunvisor, Roof Cab Sunvisor, Cab Sunvisor
3 days ago — Installation Guide - Part # SV117F. FUSO FV FS HD Euro Low Roof Cab. Sunvisor. Tools required: - Drill - 3mm & 9mm drill bits - Tec screws & bit (for ...
3 days ago —
File Info : application/pdf, 1 Pages, 26.08KB
DocumentDocumentAIRPLEX INDUSTRIES LIMITED FIT918 AUTOMOTIVE ACCESSORY MANUFACTURERS 21 SALEYARDS ROAD, OTAHUHU, AUCKLAND, NEW ZEALAND P.O. BOX 11-286, ELLERSLIE, AUCKLAND, NEW ZEALAND PHONE 64 (9) 276-9826 - FAX 64 (9) 276-9836 Email info@airplex.com, www.airplex.com Installation Guide - Part # SV117F FUSO FV FS HD Euro Low Roof Cab Sunvisor Tools required: - Drill - 3mm & 9mm drill bits - Tec screws & bit (for temporary fastening) - Alan key for 6mm machine screw - Rivnut / Nutsert tool - Marker pen - CRC Soft Seal (or similar rust prevention) 1) Hold the sunvisor to the front of the truck to identify the 2 innermost bolts above the windscreen that align with the 2 large sunvisor holes. 2) Remove these 2 bolts from above the windscreen. 3) Offer sunvisor to cab of truck again. Use M8 bolts supplied to temporarily fix sunvisor to cab using identified holes. 4) Check alignment of sunvisor. Make sure it is level with cab. 5) Working from the centre towards the outer ends, firmly hold sunvisor against the cab and temporarily fix to the cab using the tec screws or similar. Drill all holes. 6) Remove sunvisor. On the truck, drill all new holes out to 9mm. 7) Apply anti-rust or cold galv sealant to each hole (e.g. CRC Soft Seal or similar) 8) Install supplied nutserts with nutsert tool. Set firmly. 9) Apply thread sealant to each Nutsert. 10) Offer Sunvisor back to truck. Attach with 2 x M8 bolts as before. Tighten. 11) Fix to truck using supplied cap-screw fasteners. Made in New Zealand