Edifier X2 True Wireless Earbuds Headphones

Power ON/OFF

The earbuds power on automatically when removed from the charging case. They power off when placed back into the case. A blue LED lights up for 1 second upon powering on.

Pairing

To pair the earbuds with a device:

1. Remove the earbuds from the charging case. The Red and Blue LEDs will blink rapidly.
2. On your device, navigate to Bluetooth settings and select "EDIFIER X2" to connect.

Note: For subsequent use, the earbuds will automatically connect to the last paired device.

Reset

To reset the earbuds:

1. Take the earbuds out of the charging case.
2. Ensure no Bluetooth devices are connected. Press and hold the touch panel on either earbud for approximately 8 seconds until the blue LED blinks rapidly. This will reset and turn off the earbuds. (If both left and right earbuds are connected, the other side will also reset and turn off).
3. Place the earbuds back into the charging case, then remove them again.
4. Select "EDIFIER X2" in your device's Bluetooth settings to connect.

Left & Right Connection

To connect the earbuds to each other or to a new device:

1. Cancel Left & Right Connection: Disconnect the earbuds from any devices. Tap the touch panel on both earbuds 5 times. The blue LED will remain steadily lit. Once the connection is canceled, place the earbuds back into the case.
2. Start Left & Right Connection: Remove the earbuds from the case and disconnect them from any devices. Tap the touch panel on both earbuds 2 times. The blue LED will blink rapidly.
3. Once the connection is successful, select "EDIFIER X2" in your device's settings to connect.

Charging

Earbuds

When you hear a low battery prompt tone, place the earbuds in the charging case to charge them. The red LED on the earbuds is steadily lit while charging and turns off when fully charged.

Charging Case

Connect the charging case to a power source using the included Type-C charging cable. The red LED on the case is steadily lit while charging and turns off when fully charged.

Input Specifications:

• Earbuds: 5V ⎓ 200mA
• Charging Case: 5V ⎓ 1A

Controls

The touch panels on both the left and right earbuds can be used to control playback, calls, and voice assistant.

Note: Please do not charge the product if sweat or other liquids are present inside the charging port, as this may damage the product. Images are for illustrative purposes only and may differ from the actual product.