stm-931-283Z-01

Product Overview and Setup

Illustration showing the 3-in-1 wireless charging station, designed to charge a smartphone, an Apple Watch, and AirPods simultaneously. The station features a stand for the phone, a pad for earbuds, and a magnetic puck for a watch. A power adapter and cable are also depicted.

Diagram illustrating the connection of the power adapter to a standard wall outlet.
* Note: Only use certified 18W 9V/2A adapter.

Step-by-step visual guide (A-E) demonstrating device placement for charging:
(A) Smartphone, Apple Watch, and AirPods case are positioned near their respective charging points. Green arrows indicate placement.
(B) Devices are correctly placed on the charger. Green lightning bolt symbols ⚡ indicate active charging for the phone, watch, and earbuds.
(C) Smartphone is shown charging on the main stand.
(D) Apple Watch is shown charging on its dedicated magnetic puck.
(E) AirPods charging case is shown charging on its base.

IMPORTANT SAFETY INSTRUCTIONS

Before using the unit, please read the user manual carefully.

• Do not store the device in high-temperature environments, including heat caused by intense sunlight or other forms of heat. Do not place the device in fire or other excessively hot environments. Exposure to fire or temperatures above 212°F (100°C) may cause explosion.
• Do not use the wireless charger in excess of its output rating. Overloading outputs above the rating may result in a risk of fire or injury to persons.
• Do not expose the wireless charger to rain or snow.
• Do not modify, repair, or disassemble the unit. If issues arise, please contact the manufacturer.
• Switch off the wireless charger when not in use.
• The wireless charger will automatically switch off when disconnected from its wall charger.

FCC Statement

This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: 1) this device may not cause harmful interference, and 2) this device must accept any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

Radiation Exposure Statement

This device complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. During the operation of the device, a distance of 15 cm surrounding the device and 20 cm above the top surface of the device must be respected.