PT-FW530 | Panasonic Connect
Instructions for Panasonic CONNECT models including: PT-FW530 LCD Projector, PT-FW530, LCD Projector, Projector
File Info : application/pdf, 3 Pages, 354.87KB
DocumentDocumentLCD, 4500 lumens, WXGA, 10,000:1 contrast ratio, Digital Link, long lamp and filter relpacement cycle PT-FW530 Price priority and easy installation LCD projector Designed to easily replace current projection installation in education and corporate environments Key Features LCD, 4500 lumens, WXGA Long lamp replacement cycle of 8,000 hours and filter replacement cycle of 16,000 hours. Dust resistant design for lasting brightness 1.8x zoom lens and wide horizontal and vertical lens shift for flexible installation 10,000:1 contrast ratio P T- F W 5 3 0 https://eu.connect.panasonic.com/g b/en/products/projectors/pt-fw530 Power Supply AC100 - 240V 4.5 - 1.8A 50Hz/60Hz Power Consumption 400W Power Consumption | Standby Mode 0.5W, 0.3W (Taiwan) (Eco) Power Consumption | Standby Mode 12W (Normal) Power Consumption | Standby Mode 30W (Normal and Audio Monitor Out) BTU Value Max 1,365 BTU LCD Panel | Panel Size 16.3 mm (0.64 in) diagonal (16:10 aspect ratio) LCD Panel | Display Method Transparent LCD panel (x 3, R/G/B) LCD Panel | Drive Method Active matrix LCD Panel | Pixels 1,024,000 (1,280 x 800) x 3, total of 3,072,000 pixels Lens Manual zoom (throw ratio 1.22-2.26:1), Lamp Manual focus, F 1.6-2.2, f 17.1-31.7 mm 270 W UHM lamp Lamp replacement cycle 6,000 hours (lamp power: Normal), 8,000 hours (lamp power: Eco) This is the maximum value when the lamp is turned on for 2 hours Screen Size Brightness and off for 0.25 hours. 1.02- 7.62 m (40-300 inches) (16:10 aspect ratio) 4,500 lumens Center-to-Corner Uniformity Contrast (Lamp power: Normal, Dynamic mode, Iris off, Daylight View:off, Auto Power Save:off) 90% 10,000:1 (Lamp power: Normal, Dynamic mode, Iris on, Daylight View:off, Auto Power Save:off) Resolution 1,280 x 800 pixels Scanning Frequency | HDMI/DIGITAL fH: 15- 91kHz, fV: 24 - 100Hz, dot clock: 25 - 162 MHz LINK Scanning Frequency | RGB fH: 15- 91kHz, fV: 24 - 100Hz, dot clock: 162 MHz or lower Scanning Frequency | YPBPR (YCBCR) 525i (480i): fH15.73 kHz; fV59.94 Hz, 625i (576i): fH15.63 kHz; fV50 Hz, 525p (480p): fH31.47 kHz; fV60 Hz, 625p (576p): fH31.25 kHz; fV50 Hz, 750 (720)/60p: fH45.00 kHz; fV60 Hz, 750 (720)/50p: fH37.50 kHz; fV50 Hz, 1125 (1080)/60i: fH33.75 kHz; fV60 Hz, 1125 (1080)/50i: fH28.13 kHz; fV50 Hz, 1125 (1080)/25p: fH28.13 kHz; fV25 Hz, 1125 (1080)/24p: fH27.00 kHz; fV24 Hz, 1125 (1080)/24sF: fH27.00 kHz; fV48 Hz, 1125 (1080)/30p: fH33.75 kHz; fV30 Hz, 1125 (1080)/60p: fH67.50 kHz; fV60 Hz, 1125 (1080)/50p: fH56.25 kHz; fV50 Hz Scanning Frequency | Video/S-Video fH: 15.75 kHz, fV: 59.94 Hz [NTSC/NTSC4.43/PAL-M/PAL60] Keystone Correction Range Optical Axis Shift Installation Speaker Terminals | HDMI In 1/HDMI In 2 | HDMI 19-Pin x2 fH: 15.63 kHz, fV: 50 Hz [PAL/PAL-N/SECAM] Vertical ±35°, horizontal ±35° Vertical: ±60% (Manual) Horizontal: ±30% (Manual) Ceiling/flor, front/rear 4.0 cm (1-9/16 in) 10W (monaural) x 1 Deep Color, compatible with HDCP, Audio signal: linear PCM Terminals | Computer 1 In Terminals | Computer 1 In | R, G, B (sampling frequencies: 48 kHz, 44.1 kHz, 32 kH z) D-sub HD 15-pin (female) x 1 0.7 Vp-p, 75 ohms, (G: 1.0 Vp-p, 75 ohms for sync on G) H D/VD, SYNC: TTL, high impedance, positive/negative automatic Terminals | Computer 1 In | Y, PB, PR Y: 1.0 Vp-p (including sync signal), (Y, CB, CR) PBPR(CBCR): 0.7 Vp-p, 75 ohms Terminals | Computer 1 In | Y/C Y: 1.0 Vp-p (including sync signal), C: 0.286 Vp-p, 75 ohms Terminals | Computer 2 In/Computer D-sub HD 15-pin (female) x 1 1 Out Terminals | Computer 2 In/Computer 0.7 Vp-p, 75 ohms, (G: 1.0 Vp-p, 75 ohms for sync on G) 1 Out | R,G,B H D/VD, SYNC: TTL, high impedance, positive/negative automatic NOTE: SYNC/HD and VD terminals do not accept tri-level sync signals. Terminals | Computer 2 In/Computer Y:1.0 Vp-p (including sync signal), 1 Out | Y, PB, PR (Y, CB, CR) PBPR(CBCR): 0.7 Vp-p, 75 ohms Terminals | Video In Pin jack x 1, 1.0 Vp-p, 75 ohms Terminals | Audio In 1/Audio In 2 M3 x 2, 0.5 Vrms, input impedance: 22 kilohms or more Terminals | Audio In 3 Pin jack(L, R) x 1, 0.5 Vrms, input impedance: 22 kilohms or more Terminals | Variable Audio Out M3 x 1 (monitor out, stereo) Terminals | Serial In Terminals | DIGITAL LINK/LAN 0-2.0 Vrms, variable, output impedance: 2.2 kilohms or less D-sub 9 p x 1, for external control (RS-232C compliant) RJ-45 x 1 (HDBaseT? compatible), 100Base-TX, PJLink?(Class 1), Deep Color, compatible with HDCP Terminals | LAN A udio signal: linear PCM (sampling frequencies: 48 kHz, 44.1 kHz, 32 kHz) RJ-45 x 1 for network connection 10Base-T/100Base-TX, Terminals | Wireless Terminals | DC Out Power Cord Length Cabinet Materials Dimensions (W x H x D) compatible with Art-Net, PJLink?(Class 1) USB Type A x 1, for wireless projection with optional dongle (ET-WML100) USB Type A x 1, for power supply (DC5 V, max 900 mA) 2.0 m (6 ft7 in) Molded plastic 498 x 145 x 398.3mm Weight Operating Noise Operating Environment | Operating Temperature Operating Environment | Operating Humidity Technology (19-19/32 x 5-11/16 x 15-11/16 in ) with supplied lens Approx. 7.9kg (17.4lbs) 29 dB (Eco), 33 dB (Normal) 0-40 °C (32-104 °F) 20%-80% (no condensation) LCD