Yahoo Search
Instructions for PLASTICADE models including: Rubber Speed Bumps, Speed Bumps, Bumps
File Info : application/pdf, 1 Pages, 559.64KB
DocumentDocumentSpeed Bump, Speed Hump, & Parking Stop Installaon Instrucons Speed Bumps, Speed Humps & End Caps: Plascade.com 800-772-0355 Leave 1"- 3" between Speed Bumps for drainage and expansion. Product can be cut with a ulity knife if necessary. Use both Adhesive & Hardware for installaon under the following condions: - More than 4 trips per day with heavy trucks (e.g. garbage trucks). - Installaon on an incline - All Speed Hump installaons Cauon: - Not designed for speeds over 15 mph. - Sweepers must raise brushes before driving over. - Remove Speed Bumps and Speed Humps when snowplows are in use. Posion Speed Bump, Speed Hump, End Caps or Parking Stop and mark holes. ASPHALT INSTALLATION - Use 5/8" washers and 14"x 1/2" rebar spikes. For Speed Humps, also use adhesive. 1. Drill 1/2 " diameter pilot holes through asphalt, to depth of 3". 2. Clean installaon area. Put product in place. Put washers in place. 4. Start all spikes before completely seng any. CONCRETE INSTALLATION - Use lag bolts with washer and shield. 4 1/2" for Speed Bumps & Humps, 6" for Parking Stops. For Speed Humps, also use adhesive. 1. Drill 3/4" holes, 2" deep and insert shield (threaded end goes in first). For maximum expansion the shield should protrude slightly above concrete surface before seng. 2. Clean installaon area. Put product in place. Put washers in place. 3. Put bead of adhesive on leading edges of Speed Humps and End Caps. 4. Insert lag screw - start all lags before ghtening any. Tighten with wrench unl firm resistance is felt. ADHESIVE INSTALLATION (Parking garages: adhesive alone is enough) 1. Prepare rubber product: Brush holes and blow out debris. Wire brush the boom to remove any residue from the mold release used in the manufacturing process. 2. Put rubber product in place. Mark perimeter and drill holes (if using hardware). 3. Use 10 ounces of construcon grade adhesive such as PL Premium Polyurethane, or a 2-tube epoxy, such as Simpson ET-22. Buy these products locally. Epoxy dries hard, while Urethane remains flexible. Use whichever product is appropriate for your application. 4. Prepare installaon surface as per adhesive direcons. 5. Mix enough epoxy for one installaon or use a 10 oz. tube of PL Premium. 6. Fill the installaon holes to 2" from top with adhesive. 7. Apply adhesive to boom of Speed Bump/Speed Hump/Car Stop. Set in place. 8. Install washers and hardware (see instrucons above). 9. If using adhesive only, place sandbags on top unl adhesive is dry to prevent unexpected movement of product. 10. Allow seng and curing me according to adhesive direcons. Rev. 6/2022