EnjoyBasics Tension Curtain Rod

Installation Guide

Attention

WARNING: CHOKING HAZARD - Small parts. Not for children under 3 yrs.

Instruction is for reference only, please refer to the actual order.

Step 1: Determine the required length according to wall distance.

[Diagram: Measuring the wall distance to determine the rod length.]

Step 2: Assemble curtain rod, and hang the curtain.

[Diagram: Assembled curtain rod with curtain. Labels indicate 'Splicing Rod' (G1, G2) and 'Telescoping Rod' (A, B).]

Note: The number of splicing rods (G1, G2) depends on the required length. Assemble according to your needs.

Step 3: Rotate the telescoping rod (A) and extend it about 1-3 inches longer than the required length.

[Diagram: Telescoping rod (A) being rotated and extended.]

Step 4: Refer to the picture, compress the end rod (C) and push the rod up against the wall until it is level.

[Diagram: End rod (C) being compressed and the rod pushed against the wall until level.]

Step 5: Twist the telescoping rod (A) to fix and pull the rod slightly to ensure it is firm.

[Diagram: Telescoping rod (A) being twisted to fix and pulled slightly to ensure firmness.]

Step 1: Determine the required length according to window size.

[Diagram: Measuring the window size to determine the rod length.]

Step 2: Assemble curtain rod, and hang the curtain.

[Diagram: Assembled curtain rod with curtain. Labels indicate 'Splicing Rod' (G1, G2) and 'Telescoping Rod' (A, B).]

Note: The number of splicing rods (G1, G2) depends on the required length. Assemble according to your needs.

Step 3: As shown, drill holes, install wall anchors, then mount the curtain rod holders with screws.

[Diagram: Drilling holes, installing wall anchors, and mounting curtain rod holders with screws.]

Step 4: Rotate the telescoping rod (A) and extend it about 1-3 inches longer than the required length.

[Diagram: Telescoping rod (A) being rotated and extended.]

Step 5: Refer to the picture, compress the end rod (C) and push the rod up against the wall until it is level.

[Diagram: End rod (C) being compressed and the rod pushed against the wall until level.]

Step 6: Twist the telescoping rod (A) to fix and pull the rod slightly to ensure it is firm.

[Diagram: Telescoping rod (A) being twisted to fix and pulled slightly to ensure firmness.]

The number of splicing rods is refer to the actual order. Telescoping Rod: Stretch to adjust the size flexible.