User Manual for Mercury models including: Netcomm NF4V, Fibre WiFi Gigabit Modem Router, Netcomm NF4V Fibre WiFi Gigabit Modem Router, WiFi Gigabit Modem Router, Gigabit Modem Router, Modem Router, Router
Jun 13, 2022 — (If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the back for. 10 seconds).
File Info : application/pdf, 2 Pages, 180.92KB
DocumentDocumentNetcomm NF4V Fibre Configuration Using your own router? No worries, we've got you covered! Log into the gateway: 1. Ensure your device is connected to the Router (preferably via cable) 2. Open a web browser 3. Type the following in the address bar at the top: 192.168.20.1 4. Default Username: admin 5. Default Password: password This should then give access to the router's user interface (If the password is incorrect you will need to Factory Reset the router by pushing the Inset Reset button on the back for 10 seconds) How to add correct settings for the Mercury network: 1. From the menu on the left select: Advanced Setup 2. From the sub-menu select: WAN Service In the page Select the Remove tickbox for all connections: 1. Select: Remove 2. Select: Add Ensure the following settings are changed: 1. Wan Service Int Config: ETH4/ETH4 2. Select: Next 3. WAN Service Type: PPP over Ethernet (PPPoE) 4. Service Decription: (left as is) 5. 802.1P Priority: 0 6. 802.1Q VLAN ID: 10 7. Select: Next 8. PPP Username: (your mercury acct number)@mercurybroadband.co.nz 9. PPP Password: password 10. PPPoE Service Name: Mercury 11. All other settings can be left as is 12. Select: Next 13. Leave this page as is 14. Select: Next 15. Select anything in the right box and move to left box 16. Select: Next 17. Select: Apply/Save You should now be connected to Fibre!