Fishbone Offroad - YouTube
YouTube
Installation Guide for Fishbone models including: FB22341 Barracuda Bull Bar, FB22341, Barracuda Bull Bar, Bull Bar, Bar
Fishbone Barracuda Bull Bar for Jeep Wrangler and Jeep Gladiator Online - offroadten.shop
Fishbone Offroad Barracuda Front Bumper Stinger Bar - 2007-Current Jeep Wrangler/Gladiator – The Urban Trail Jeep Accessories
Fishbone Barracuda Modular Bumper - Base – Off Road Tents
File Info : application/pdf, 3 Pages, 662.94KB
DocumentDocumentFB22341, FB22342, FB22343, FB22344 2007-Current JK/JL Wrangler & JT Gladiator Barracuda Front Bumper & Accessories FB22341 FB22342 FB22343 FB22344 REQUIRED TOOLS 19mm Socket 17mm Wrench 17mm Socket Help of a Friend FB22341 CONTAINS QTY M12 Hex Bolt 6 M10 Hex Bolt 8 M12 Flat Washer 12 M10 Flat Washer 16 M12 Hex Nut 6 M12 Lock Washer 6 8 M10 Lock Washer 8 M10 Hex Nut FB22342 & FB22343 QTY CONTAINS M12 Hex Bolt 4 M10 Hex Bolt 8 M12 Flat Washer 8 M10 Flat Washer 16 M12 Lock Washer 4 M10 Lock Washer 8 M12 Hex Nut 4 M10 Hex Nut 8 D-Rings 2 Foam FB22344 CONTAINS QTY M10 Hex Bolt 8 M10 Flat Washer 8 M10 Lock Washer 8 M10 Hex Nut 8 D-Rings 2 [Title]00 FB22341, FB22342, FB22343, FB22344 2007-Current JK/JL Wrangler & JT Gladiator Barracuda Front Bumper & Accessories 1) REMOVE EXISTING BUMPER Begin removing your existing bumper and any accessory that may get in the way. We show how to uninstall your JK/JL/JT factory bumper over on our YouTube channel: www.FishboneOffroad.TV 2) ASSEMBLE THE BUMPER With a 19mm socket, install the fairlead onto the top of the bumper with 2 of the included M12 bolts, washers, and nuts. Place the bar up to the bumper and secure only the top plate with 4 M12 bolts, 8 washers, and nuts with a 19mm socket. If you purchased the Bull Bar or Stinger, apply the foam padding to the inside of the mounting brackets. 1 [Title]00 FB22341, FB22342, FB22343, FB22344 2007-Current JK/JL Wrangler & JT Gladiator Barracuda Front Bumper & Accessories 3) INSTALL BUMPER With the help of a friend, hold the bumper up to the frame and center it on the bolt holes. If you own the base model or any bar, secure it to the frame with 8 M10 bolts, 16 washers, and nuts with a 17mm socket and wrench. Followed by installing your D-Rings. If you purchased the D-Ring set, with the help of a friend, hold the bumper into place while you align the D-Ring caps with the bolt and frame holes. With 8 M10 bolts, 16 washers, and nuts and a 17mm socket and wrench, secure the bumper to the frame. Followed by installing your D-Rings. 2 [Title]00