Axess PABT6028 Single 6.5" Portable BLUETOOTH SPEAKER
For correct operation, please read this manual carefully before using. Any content revision of the manual will not be declared again, and Axess Products Corporation is not responsible for consequences caused by fault or oversight of this manual.
Axess Logo: A stylized 'A' followed by 'XESS' with radiating waves above and below the 'X', signifying wireless connectivity. Tagline: WHERE CREATIVITY & TECHNOLOGY MEET
TO CUSTOMERS
Thank you for your support and trust in purchasing the products of Axess Products Corporation. To fully exert the function of the product, we suggest you read the operating instructions carefully before using it, for the convenience of grasping the connection method and using points. Please take care of the operating instructions after reading it for the purpose of further reference.
SPECIFICATIONS
- Speakers: Double 6.5" subwoofers + 2x 3" Tweeters
- Bluetooth Range: 10 meters
- LED Lights: Brilliant LED lights
- TWS Link+: True Wireless Stereo
- Card Slots: TF card slot
- Inputs: AUX and USB input
- Microphone Input: MIC jack
- FM Radio: FM radio function
- Output Power: 400 Watt (PMPO)
- Battery Capacity: 3000mAh
- Voltage: 7.4 Volt Boost
- Charging Port: DC 5V
- Frequency Response: 150Hz - 18KHz
PANEL BUTTONS
Description of the speaker's top panel controls:
- OFF/ON: Power switch.
- DC 5V: Charging port.
- EQ: Equalizer button.
- ≪: Play previous music/station.
- ❙❙: Play/pause music; long press for automatic FM station search.
- ≫: Play next music/station.
- M/?️: Mode selection button (cycles through Bluetooth, TF, USB, Line-in, FM). Long press to turn LED lights ON/OFF.
- AUX: 3.5mm AUX input jack for connecting external audio devices.
- MIC: Microphone input jack for wired microphones.
- ECHO: Microphone echo control.
- LED Dial: Master volume control dial.
- USB Port: Supports USB drives for playing MP3 and WAV format music.
- TF Card Port: Supports TF cards for playing MP3 and WAV format music.
OPERATING BLUETOOTH MODE
- After powering ON, press the "MODE" button until "Bluetooth" appears on the display.
- On your mobile device, turn on Bluetooth, search for "PABT6028", and confirm the connection.
- A beep tone indicates a successful pairing.
OPERATING AUX MODE
- Connect one end of a 3.5mm audio cable to the speaker's AUX jack and the other end to your mobile device (cellphone, laptop, tablet, etc.).
- Control music playback using the speaker's playback buttons or directly from your mobile device.
OPERATING LED FUNCTION
- Press and hold the "MODE" button to turn the LED display lights ON or OFF.
OPERATING TWS FUNCTION
- Pair one speaker with your mobile device via Bluetooth.
- Ensure the second speaker is also powered on and in Bluetooth mode.
- Double-click the "PLAY/PAUSE" button on the second speaker to activate its TWS mode.
- If both speakers are close, they will connect automatically and play music simultaneously.
CHARGING
- Connect the USB charging cable to the DC 5V charging port.
- Charge the speaker using a wall plug or a computer USB port.
- The charging indicator light on the right side of the LED screen will illuminate while charging and turn off when fully charged.
NOTE:
- Turn off the device when not in use to conserve battery life.
- Lower the volume before turning off the device to maintain the (sub)woofer in good condition and prevent damage.
ATTENTION!
FOR FIRST TIME USE: FULLY CHARGE THE DEVICE UNTIL THE LIGHT INDICATOR TURNS OFF AS INSTRUCTED IN THE MANUAL.
This can take up to approximately 8 hours to fully charge. If not fully charged, the device may not function at full capacity.
Axess Products Corporation
6649 Valjean Ave. Van Nuys, 91406
Tel. 818-785-4000 Fax. 818-785-5081 info@axessusa.com
Questions? Comments? Contact Axess Products Corporation at support@axessusa.com
© 2018 Axess Products Corporation. All rights reserved.