User Manual for CHORUS models including: WA38 Wylde Audio, WA38, Wylde Audio, Audio
prieš 6 dienas — 1 FOOTSWITCH toggles effect on/bypass (blue LED indicates on). 2 THRU OUTPUT jack engages stereo mode. 3 LEVEL knob controls overall effect volume.
MXRÂ WYLDE AUDIO CHORUS
File Info : application/pdf, 4 Pages, 585.92KB
DocumentDocumentWA38 Wylde Audio Chorus Celebrate the 20th anniversary of the explosive collaboration between Dunlop and Zakk Wylde with the MXR® Wylde Audio Chorus. This pedal is Zakk's secret weapon for thickening up walls of distortion and adding liquid dimension and texture to clean passages. jimdunlop.com/wa38 External Controls 4 5 3 6 7 2 1 1 FOOTSWITCH toggles effect on/bypass (blue LED indicates on) 2 THRU OUTPUT jack engages stereo mode 3 LEVEL knob controls overall effect volume 4 LOW knob controls amount of low frequency cut 5 HIGH knob controls amount of high frequency cut 6 DEPTH controls overall intensity of chorus effect 7 RATE knob controls speed of chorus effect WA38 | MXR® Wylde Audio Chorus 2 Basic Operation Power The MXR® Wylde Audio Chorus is powered by a single 9-volt battery (remove bottom plate to install), a 9-volt AC adapter such as the Dunlop ECB003, or an MXR® BrickTM Series power supply. Directions 1. Run a cable from your guitar to the WA38's INPUT jack and run another cable from the WA38's OUTPUT jack to your amplifier. Optional Stereo Mode: run an additional cable from the THRU OUTPUT jack to the input of a second amp. Using this jack automatically sends the delayed signal only to the MONO output jack when the effect is on and outputs a buffered copy of the input signal. 2. Start with all knobs at 12 o'clock. Turn the effect on by depressing the footswitch. 3. Rotate the DEPTH knob clockwise to increase the intensity of the effect or counterclockwise to decrease it. 4. Rotate the RATE knob clockwise to increase the speed of the chorus effect or counterclockwise to decrease it. 5. Rotate the LEVEL knob clockwise to increase overall effect volume or counterclockwise to decrease it. 6. Rotate the LOW knob clockwise to retain more low end or counterclockwise to cut more low end. 7. Rotate the HIGH knob clockwise to retain more high end or counterclockwise to cut more low end. WA38 | MXR® Wylde Audio Chorus 3 Specifications Input Impedance Output Impedance Noise Floor* Tone Controls (Low) Tone Controls (High) Bypass Current Draw Voltage Requirements *Tone controls center, all others max CW, A-weighted 1 M 1 k -96 dBV (effect on) -106 dBV (bypass) 70 Hz to 800 Hz 12 dB/oct shelf 660 Hz to flat 6 dB/oct shelf Buffered 13 mA 9 volts DC WA38 | MXR® Wylde Audio Chorus 4