Instruction Manual
This manual provides essential information for the operation and maintenance of the HYCHIKA OS300W Random Orbital Sander. Please read carefully before use.
Specifications
| Model | OS300W |
| Rate | 120V/60HZ 2.5A |
| No-load speed | 6000-13000 min⁻¹ |
| Pad size | 5 Inch (125mm) |
| Paper type | Hook & Loop |
| Cord length | 6 Feet |
Important Safety Information
CALIFORNIA PROPOSITION 65 WARNING: This product may contain chemicals known to the state of California to cause cancer or reproductive harm. Always use in a well-ventilated area and wear appropriate safety equipment.
General Warnings: Always read and understand all safety instructions before operating the tool. Pay close attention to safety symbols and their explanations.
- Ensure your work area is clean and well-lit.
- Do not operate in explosive environments.
- Keep bystanders and children away.
- Always wear eye protection, dust masks, and hearing protection as needed.
- Ensure the power source voltage matches the tool's specifications.
- Do not abuse the power cord.
- Stay alert and use common sense when operating the tool.
- Dress properly and avoid loose clothing or jewelry.
- Remove adjusting keys before turning the tool on.
- Maintain proper footing and balance.
- Use clamps to secure the workpiece.
- Do not force the tool; use the correct tool for the job.
- Disconnect the power plug before making adjustments or changing accessories.
- Store idle tools out of reach of children.
- Maintain tools with care and keep cutting edges sharp.
- Use only manufacturer-recommended accessories.
- Do not alter or misuse the tool.
Operation
ON/OFF Switch: Located on the front of the handle. Depress to the 'I' position to turn ON, and to the '0' position to turn OFF.
General Sanding: Place the sander on the workpiece before turning it ON. Move in long, sweeping strokes parallel to the grain. Adjust pressure based on the desired finish. Keep the sanding disc flat on the workpiece.
Sandpaper Selection: Choose sandpaper grit based on the workpiece material and the desired finish. Start with coarser grits and gradually move to finer grits.
Maintenance
WARNING: All repairs should be performed by qualified service personnel. Always turn off and unplug the sander before performing maintenance or cleaning.
- Inspect the pad for wear or damage.
- Keep ventilation slots clean to prevent motor overheating.
- Clean the tool housing with a soft sponge and damp cloth. Avoid using solvents on plastic parts.
- Use a dust collector and empty it frequently.
Contact Information
For any issues, please contact support@hychika.com.
Manufacturer: TSP Tool Group LIMITED
Web: www.HYCHIKA.com
Address: RM 1405A CHUANG KLU COMM BLDG 47-51, SHAN TUNG ST MONGKOK, HK, China
