Mini Bluetooth Loudspeaker Model Kit – makcosmos
User Manual for Geekbuying models including: MKYX06, Makcosmos MKYX06 Mini Bluetooth Loudspeaker Model Kit, Makcosmos MKYX06, Mini Bluetooth Loudspeaker Model Kit, Bluetooth Loudspeaker Model Kit, Loudspeaker Model Kit, Model Kit, Kit
Makcosmos MKYX06 3D Printing Mini Bluetooth Loudspeaker Model Kit
File Info : application/pdf, 4 Pages, 3.95MB
DocumentDocumentMini Bluetooth Loudspeaker Model Kit User Manual Welcome to use Makcosmos products, and hope that this product can "Print Happiness" with you; The following are the installation instructions for the bluetooth speaker kit: 1. After unpacking, check whether there are any missing parts (if so, please contact sales as soon as possible) 2. Visit the bellowing address to download and print the model. After printing, remove the supports carefully and check whether the prints are missing https://www.makcosmos.com/products/mini-bluetooth-loudspeaker-model-kit 3. Place the prints on the desktop and prepare the required accessories (as shown below) Mini Bluetooth Loudspeaker Model Kit User Manual 4. Place themain board into therear cover and secure it withscrews (as shown below) 5. Apply glue to the outer shell circle and stick theloudspeaker (as shown below) 6. Apply glue to the battery and stick it to the inner wall. Be careful to stick it to the sides which is far from the positioning pillar to avoid the terminal connection failure (as shown below) Mini Bluetooth Loudspeaker Model Kit User Manual 7. After the glue is completely dried, connect the terminal to the main board. Pay attention to the markings on the main board and do not connect the terminals incorrectly (as shown below) 8. Install the cover and complete the installation (as shown below) Mini Bluetooth Loudspeaker Model Kit User Manual Product Showcase: