TerraKing FS2 Fill Sensor

Key Features

• Alerts when your collection system is full.
• Lightweight and compact design.
• Adjustable sensitivity levels for different materials.
• Rechargeable battery for convenience.

Kit Includes

• Fill Sensor (1)
• Mounting Plate (1)
• Sheet Metal Screws (2)
• Plastic Screws (2)
• USB Cable (1)

For a complete manual and parts list, visit terraking.com.

Important Information

• Battery Warning: Contains a lithium-ion/polymer cell battery. Keep away from children. Do not attempt to reset the battery.
• Hearing Protection: Prolonged use without hearing protection may cause hearing loss. Wear appropriate protection.
• WEEE Notice: This symbol is valid in the EU. Contact local authorities for proper disposal methods.

Limited Warranty

TerraKing products are warranted against defects in material and workmanship for one year for residential use and six months for commercial use from the date of purchase. This warranty applies when the product is properly assembled, installed, used, and maintained according to instructions. Failure to do so will void the warranty.

Quick Start Guide

Initial Setup

• Charge the sensor fully before first use.
• Connect the included USB cable for charging. Status lights indicate battery level.
• A low battery is indicated by the buzzer chirping twice per minute.

Mounting

• Plastic Hoppers: Attach the mounting plate using self-drilling screws.
• Metal Hoppers: Use the included mounting template to drill two 1/8 inch holes. Attach the mounting plate with sheet metal screws.
• Align the sensor with the mounting plate slots and rotate counter-clockwise to lock.
• Turn the sensor on after mounting for calibration.

Operation

• Power On/Off: Press the power button until status lights illuminate. Press and hold to turn off.
• Modes: The sensor operates in Scan Mode (searching for material), Alarm Mode (hopper is full, indicated by blinking lights and buzzer), and Sleep Mode (activates after inactivity, awakes upon movement).
• Sensitivity: Cycle through sensitivity levels (1-5) by pressing the power button. Level 1 is for wet grass, Level 5 for dry leaves.