NHBS Moth Trap Instructions for Assembly
Step 1: Assemble the Trap Container
Description: Assemble the trap container by attaching the walls and base together using the Velcro strips.
[Image Description: Hands are shown assembling the main body of the moth trap by connecting the side panels to the base using Velcro strips.]
Step 2: Attach the Base
Description: Ensure the base is attached on the inside of the trap to prevent rain from entering.
[Image Description: The base of the trap is shown being secured inside the main container walls.]
Step 3: Slide Wall Supports
Description: Slide the wall supports onto the container walls without baffles (sloping panels).
[Image Description: Hands are shown sliding the internal wall supports into place within the trap's container walls.]
Step 4: Place Egg Boxes and Baffles
Description: Place egg boxes or similar inside the trap and flip the baffles over so that they rest on the wall supports.
[Image Description: Egg boxes are placed inside the trap, and the sloping baffles are shown flipped over to rest on the wall supports.]
Step 5: Insert Light Holder
Description: Slide the light holder into the corresponding slots on the wall supports.
[Image Description: Hands are shown inserting the light holder mechanism into the designated slots on the trap's internal supports.]
Step 6: Screw in Blacklight Bulb
Description: Screw in the blacklight bulb tightly to ensure a waterproof seal.
[Image Description: A blacklight bulb is being screwed into the light holder, ensuring a tight fit.]
Step 7: Connect to Power
Description: Plug the trap into a mains power source.
[Image Description: The fully assembled moth trap is plugged into a mains power outlet, and the blacklight is illuminated.]
Important Note
Please note: When operating this trap, please take care not to over-tighten the bulb, as this can damage the contacts within the bulb holder.