Snailfly Fit for Lexus RX350 RX350L RX450h RX450hL 2016-2022 Running Boards Side Step Board : Automotive
Installation Instructions Please read the instructions carefully before installing the side step Steps 1 Front BracketPlease remove the rubber plug of the third hole from the front outside of the car chassis and then put T-screw into the hole.Remove the M6 screw inside. Please check the positions in the picture below Put on the front Bracket,screw on the front side of the bracket.Screw on the rear part with M6 screw.Please do not tighten them. 3 Rear BracketFind a oval hole at the rear side of the car chassis.Remove 2 clips of outside place.Find a hole hidden behind the guard plate and cut out a small hole to expose the factory hole. 4 Put the pedals on the brackets.Fix the pedals to the brackets.Adjust the positions of the bracekts to the best placc.Then tighten all screws.Install clips back. 2 Middle BracketRemove 2 clips which are at the middle side of the car chaais.Find a hole hidden inside the guard plate.Cut out a small hole to expose the factory hole. put on the T-screw Put on the middle bracket.Screw on,but do not tighten it. 5 Make sure that the brackets and peadls are steady. Put T style screws into these holes and then put on rear brackets.Screw on but do not tighten them. Note:The intallation method of the left and right side is same.福昕PDF打印机 版本 8.3.0.0331