Instruction Manual for EXCURSION models including: SXA25K, SXA35K, SXA45K, SXA2SK Street Comp Full Bridge Amplifier, SXA2SK, Street Comp Full Bridge Amplifier, Comp Full Bridge Amplifier, Bridge Amplifier, Amplifier
eXcursion SXA 45K COMP | Caraudio-Store.de, 3.499,00 €
REAR PANEL LAYOUT
9
10 11 12
12 11 10
9
11. REM Terminal At least one Remote terminal is to connect with headunit 12V remote output to turn ON/OFF the
amplifier according opera ng of headunit. If there are more amplifier distributed via these terminals it might be necessary, depending on REM performance of headunit, to install an addi onal relay. 12. (+)12 Volt Ba ery Terminal
Connect this terminals with proper 0 GA size OFC Power Cable through a Fuse to the posi ve terminal of the car ba ery or the posi ve terminal of an isolated external car audio ba ery. WARNING: Always protect the Power Cable via Fuse less than 12inch (30cm) from ba ery terminal. WARNING: SXA Amplifiers need external Fuse not less than 12inch (30cm) from Power terminal. Please follow the maximum Fuse recommenda on from Excursion SXA COMP Specifica ons.
ATTENTION: SXA25K include 4x TRIPPLE. SXA35K & 45K include 4x QUAD POWER INPUT ADAPTERS !!!
CAUTION
Installation of the amplifier should be done in the following steps: 1. Ensure that the ground is appropriate, then connect it to the amplifier. 2. Next step is to connect the +12V wire. Ensure all power terminals are used.
This cable has to be fused for safety precautions. 3. The final step is connecting the switched remote.
4
Foxit Reader PDF Printer Version 9.7.1.2227